V3800-CR-TE4(C), V3800-CR-TIE4(C), DM COMMON RAIL SYSTEM
(55) Excessive PM3 (DTC P3006 / 3701-15)
Behaviour during malfunction:
Insufficient output
Detection item:
PM accumulation level3
DTC set preconditions:
Battery voltage is normal
DTC set parameter:
PM accumulation more than trigger level
Regeneration level = 3
Engine warning light:
ON
Limp home action by engine ECU (system action):
Output limitation: Approximately 50 % of normal condition
Recovery from error:
Diagnostic counter = zero
9Y1200174CRS0443US0
1. DPF Manual Regeneration
1. Start DPF Manual Regeneration immediately.
NOTE
This DTC means the warning to urge to start regeneration
rather than error. (Basically, Service Call is not necessary.)
Followings are potential causes.
A low load operation has been continuing.
An engine is often left idling.
A short time operation below 30 minutes has been
continuing.
(a) DPF Manual Regeneration
Reguest Button
9Y1200174CRS0564US0
1-S275
V3800-CR-TE4(C), V3800-CR-TIE4(C), DM COMMON RAIL SYSTEM
(56) Excessive PM4 (DTC P3007 / 3701-16)
Behaviour during malfunction:
Insufficient output
Detection item:
PM accumulation level4
DTC set preconditions:
Battery voltage is normal
DTC set parameter:
PM accumulation more than trigger level
Regeneration level = 4
Engine warning light:
ON
Limp home action by engine ECU (system action):
Output limitation: Approximately 50 % of normal condition
Recovery from error:
Diagnostic counter = zero
9Y1200174CRS0444US0
1. DPF Manual Regeneration Reguest Function
1. Perform the diagnosis tool active test ("DPF Manual
Regeneration").
NOTE
Followings are potential causes.
A manual regeneration has not been carried out. Start
DPF manual regeneration immediately when the
manual regeneration warning light comes ON.
(a) CAN1 Connector
9Y1200174CRS0565US0
1-S276
V3800-CR-TE4(C), V3800-CR-TIE4(C), DM COMMON RAIL SYSTEM
(57) Excessive PM5 (DTC P3008 / 3701-0)
Behaviour during malfunction:
Insufficient output
Detection item:
PM accumulation level5
DTC set preconditions:
Battery voltage is normal
DTC set parameter:
PM accumulation more than trigger level
Regeneration level = 5
Engine warning light:
ON
Limp home action by engine ECU (system action):
Output limitation: Approximately 50 % of normal condition
Recovery from error:
Key switch turn OFF
9Y1200174CRS0445US0
1. Replace of DPF
1. Replace the DPF.
NOTE
Followings are potential causes.
A manual regeneration has not been carried out.
(1) DPF Outlet Body (5) DPF Gasket
(2) DPF Filter Comp (6) DPF Gasket
(3) DPF Collar (7) DPF Gasket
(4) DOC Catalyst
9Y1200174CRS0566US0
1-S277
