Vou will need the following tools :
Application instructions
1 Spray bottle ... a few drops of 1 Razor blade 1 Rubber squeegee 1 Cutter 1 Roll of paper
filled with water washing solution window scraper towels
and ...
1 2 3
+ 2 à 3 cm
Using the window scraper and the Wipe the window frame with Using the cutter, cut a piece of film
spray bottle of soapy water , clean a rubber squeegee and to a size 2 or 3 cm larger than the
the window pane thoroughly. a paper to window pane
4 5 6
With the help of 2 pieces of scotch While pulling the film apart from Turn the film around and apply its
tape separate the film from its its protective liner, spray the film’s adhesive side to the window pane.
protective liner. adhesive side generously with the
soapy water mix.
7 8 9
< 2 mm
Spray the film to allow the squeegee To attain a good adherence, working Cut the film to within 2 mm of the
to slide easily over it. . from top to bottom, scrape with the window pane’s edge. The film
squeegee from the center towards shouldn’t touch the frame Then
the right and left edges. squeegee to smooth out any
remaining air bubbles.
5° Minimum application temperature !
Our recommendations
METHOD.
Application should be done very carefully to obtain optimum results.
The surface to be bonded must be free from dust,
If a few defects are visible after the application, they should disappear after 3 weeks.
grease or other contaminants.
Do not clean the film during the drying period (3 to 5 weeks).
After
the drying period, the film may be cleaned with slightly soapy water.
Do not use abrasives or products containing alcohol.
Please refer to our prescription table or contact us for any question
P.A. des petits carreaux - 2 avenue des Orangers 94380 Bonneuil sur Marne - FRANCE KITPOS MATPOS
+33 (0)143 99 00 22 - info@reflectiv.com - www.reflectiv.com Surface Surface
< 3m² > 3m²
