thanks for your purchase of the
KIWI MODEL
(s
).
about this model
2.75 in. x 2 in. x 2 in.
materials needed
These are the material suggestions if you want to make the model as shown in the photo.
You can use any material or color substitutions that you would like, as long as they are in the
same quantities as the material that you are substituting.
• Glue. Preferably the liquid kind. Hot glue, glue sticks, and adhesive tape either make a
mess of your model or just don’t stick well enough to hold it together.
• 1 sheet Light Brown cardstock - 12” x 12” or 8.5” x 11”
• 1 sheet Dark Green cardstock - 12” x 12” or 8.5” x 11”
• 1 sheet Green cardstock - 12” x 12” or 8.5” x 11”
• 1 sheet Light Green cardstock - 12” x 12” or 8.5” x 11”
• 1 sheet Black cardstock - 12” x 12” or 8.5” x 11”
• 1 sheet Off-White cardstock - 12” x 12” or 8.5” x 11”
fold lines & preparation
This design may have both mountain and valley fold lines. This means that some lines will
fold in and others will fold out depending on the design. You’ll need to watch the line
pattern and be sure you are folding the paper in the right direction.
Mountain Fold Line
Valley Fold Line
Mountain Fold Valley Fold
piece identification guide
Take a moment to identify and label the pieces of the model on the reverse side after they have been cut out. ( The Piece Identification Guide
is only meant to be used as a reference for identifying pieces and should not be cut out.)
B1 B2 B3 B4 B5 B6 B7 B8
K1 G1
D1
L1
W1
page 1
1 2
B2
B1
B8
Before beginning assembly, make sure to identify, label, and fold all Attach piece B8 by starting from either end (it doesn’t really matter
your pieces. Begin assembly by gluing piece B2 to B1. Next, glue B3 to which) and work your way along to the other end until complete.
B2, B4 to B3 and so on until pieces B1 through B7 have been glued
together. Leave piece B8 for last.
3 4
Finish by gluing down the top flap. It should look like this when you are finished.
5 6
Glue piece D1 to the larger end. Be sure to try and keep it as centered Next glue on piece K1.
as possible.
page 2
7 8
Glue G1 on top of K1. Again, be careful to keep everyting centered. Glue piece L1 in the center being sure to keep the flat edges parallel
with the outer edges of the main body.
Finish by gluing on piece W1. Be careful to keep the thin parts of the
shape evenly spaced between the seed cutouts. Congratulations! You
are finished.
