0% found this document useful (0 votes)
73 views2 pages

Micro Bracelet Done

Uploaded by

ken
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
73 views2 pages

Micro Bracelet Done

Uploaded by

ken
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

World's Largest Selection Of

USA made 550 Paracord


Paracordgalaxy.com In 1,000 + Colors and
Patterns

Micro Cord Adjustable Bracelet


Materials:
Two 12 inch pieces of micro
cord
One 6 ft piece of micro cord
Beads (optional)
{Cost for this bracelet starts at $1.49}

Step 1: Lay the two 12 inch pieces over Step 2: Bring the left side A over the
the middle of the six foot piece of micro middle two cords and under the right side
cord leaving about four inches at the top. B

Step 3: Bring B under the middle two Step 4: Repeat the process with A now on
cords and up through the loop created by the right. Bring A over the middle two
A then tighten. Make sure you still have cords and under B.
four inches at the top.

Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267


Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
World's Largest Selection Of
USA made 550 Paracord
In 1,000 + Colors and
Patterns

Step 5: Bring B under the middle two Step 6: Add a bead to the middle cords
cords and up through the loop created by then continue braiding around the bead.
A. Tighten and repeat steps 2 through 5 Bring B over the middle cords and under
until you get about an inch of braid. A.

Step 7: Bring A under the middle cords Once you reach the desired length, trim
and up through the loop created by B. Add and melt the ends of A and B. Next,
a few knots and beads until you reach the overlap the middle two cords on each end.
desired length.

Using the excess from the braid, repeat Trim and melt the ends. Tie an overhand
steps 2 through 5 two or three times. knot in each of the middle cords.

Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267


Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.

You might also like