Scribd
Upload
208 views2 pages

Procedura 005 037

Uploaded by

Jasmin Kahrimanović
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
208 views2 pages

Procedura 005 037

Uploaded by

Jasmin Kahrimanović
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Procedura 005-037

Engine pump timing begins with the timing of the fuel injection pump drive gear to the camshaft gear.
See the table below to determine which letter on the fuel injection pump drive gear is aligned with the camshaft gear.

Engine Model Gear Letter


QSB3.9-30 J
QSB4.5-30 J
QSB5.9-30 C

ach key used with the Bosch VP30 injection pump has an installation arrow. The arrow must always point toward the
injection pump. The key does not contain a part number that must be matched to the injection pump dataplate.

To check the static timing:

1. Remove the front gear cover. Refer to Procedure 001-031 for front gear cover.
2. Verify the timing marks on the gear train are aligned. Each key has an installation arrow. The arrow must always
point towards the pump.
3. Verify that no gears have slipped on the shaft.

If the above checks are OK, remove the pump. Refer to Procedure 005-014.
The timing must be checked at an authorized Bosch® service shop.

You might also like