Scribd
Upload
11 views2 pages

Technical Service Information: Re4Ro1A

Uploaded by

Техник Связи
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views2 pages

Technical Service Information: Re4Ro1A

Uploaded by

Техник Связи
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

BACK

BACK
Technical Service Information

RE4RO1A
BEARING CHANGE

CHANGE: he three piece needle bearing located at the rear of the low one way clutch inner race in
RE4RO1A transmissions has changed (See Figure 1).

REASON: Improved durability.

PARTS AFFECTED:
The previous design 3 piece bearing has been replaced by 2 thrust washers (See Figure 2).

INTERCHANGEABILITY:
The 2 new design thrust washers will retro fit backwards. These thrust washers must be used
in a pair. If not, premature bearing failure, lubrication and or end play problems will arise.

SERVICE INFORMATION:
THRUST WASHER (NEW DESIGN-2 REQUIRED)..............................31508-41X01

LOW ONE WAY


CLUTCH INNER RACE

PREVIOUS DESIGN
BEARIN

Copyright © 2001 ATSG

Figure 1 95-20
AUTOMATIC TRANSMISSION SERVICE GROUP Page 1 of 2
BACK
BACK
Technical Service Information

Figure 2

Copyright © 2000 ATSG

95-20
AUTOMATIC TRANSMISSION SERVICE GROUP Page 2 of 2

You might also like