2013 - PF - DODGE DART - 2.
4L I4 MULTIAIR
23 - Body / Interior / CONSOLE, Floor/Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Unclip the shifter bezel (1), (Refer to 23 - Body/
Interior/BEZEL, Shifter - Removal).
NOTE: Do not remove the shifter bezel, as it
will fit through the opening once the
storage bin has been removed.
3. Pull the emergency brake handle (2) fully up.
4. Remove the emergency brake side cover.Remove the
emergency brake side cover.
5. Position the seat fully forward.
6. Using a small pick/pry tool or equivalent, remove
the fastener cover (3) located near the lower rear of
the console. Remove the fastener behind the cover.
Repeat on the other side.
7. Using Trim Stick C-4755 , disengage the retaining
tabs/clips securing the switch pod (2) to the
instrument panel.
8. Position the switch pod (2) slightly away from the
instrument panel and disconnect the appropriate wire
harnesses. Remove the switch pod (2).
9. Accessing from the front of the floor console (1) and
using Trim Stick C-4755 , disengage the retaining
tabs for the front gap hiders (2) and remove the gap
hiders (2).
1
10. Disconnect the floor console wiring harness
(3).Disconnect the floor console wiring harness (3).
11. Disconnect the wire connector (2) from the auxiliary
power outlet (1).
12. Remove steering column opening cover.
13. Remove the fastener (1) securing the console upper
assembly (2) to the dash panel.Remove the fastener
(1) securing the console upper assembly (2) to the
dash panel.
14. Using Trim Stick C-4755 , disengage the retaining
tabs/clips securing the console upper assembly.
15. Remove the storage bin liner.Remove the storage bin
liner.
16. Using Trim Stick C-4755 , disengage the retaining
tabs/clips securing storage bin (1) to the floor console
(2).
2
17. Remove the two fasteners (1) from the floor console
(2).Remove the two fasteners (1) from the floor
console (2).
18. Lift the console up at the rear and remove from the
vehicle.
