0% found this document useful (0 votes)
56 views4 pages

Hpom 8e1 4eth 11 463

UPCOM PDH modem 8 port

Uploaded by

cuongars
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
56 views4 pages

Hpom 8e1 4eth 11 463

UPCOM PDH modem 8 port

Uploaded by

cuongars
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

PDH Fiber Optical Multiplexer HPOM-8E1-4ETH

Managed 8E1+ 4ETH PDH Optical Multiplexer

 Features
● Provides 8*E1 G.703 transparent transmission over the fiber;
● 1 Fiber or 1+1 Fiber back up optional;
● Provide 4*100 Mbit/s Ethernet channels, Ethernet speed can be set
for each port on based on any multiples of n*32 Kbit/s;
● Provides one RS232 channel for option;
● Provide one hotline channel for option (order wire);
● Speed of optical port is 155Mbps, transmission range can reach 20, 40, 60, 80,100,120Km;
● E1 interface code is HDB3; E1 vibration characteristic conforms to ITU-T G.703、G.823 and G.742;
● Ethernet port supports full/half duplex, 10M/100M auto-adaptable, throughput is full duplex 100 Mbit/s;
● Ethernet port supports dot1Q VLAN setting possibility and port based VLAN;
● Layer2 intelligent switch possibilities for 4*Ethernet ports;
● Ethernet packet size supports 1916 byte and 4 Ethernet port could be set separately, jumbo frames are supported;
● Simultaneous 8 E1 & 100 Mbit/s full duplex operation;
● LED indicators for alarm function and can monitor remote device status;
● Support DIP switch management;
● Supports E1 local and remote loopback for installation;
● Broadcast Storm Protection, Port monitoring;
● Current alarm and alarm history database;
● GUI based RS232 NMS manager for easy and convenient monitoring and management;
● Support DC48V and AC 220V power supply;
● Support -5-65oC wide operating temperature range;
● Warranty:3years

 Introduction
HPOM-8E1-4ETH Optical multiplexer is 8*E1 G.703 + 4 Ethernet 10/100BaseT fiber multiplexer with logical
bandwidth control, QoS, and dot1Q VLAN's which allows effective transmission of those protocols over fiber
optical cable over distances more than 120 km.

UPCOM HPOM-8E1-4ETH can provide up to 8E1 interfaces and 4 Fast Ethernet interface. The Ethernet
interface can be operated in 10M/100M, half duplex or full duplex mode by either auto-negotiation or manual
setting.

HPOM-8E1-4ETH is a fiber media transport for 8E1 + 4*10/100BaseT transmission. The BNC model provides
unbalanced 75 Ohm coaxial connections while the RJ-48C model provides balanced 120 Ohm connections
over twisted pair wiring, it provides an order-wire for which a standard telephone can be used.

HPOM-8E1-4ETH provides a user RS232 transparent data link with a RJ45 connector which possesses
complete operation monitoring function. Those indicators include Loss of optical signal, LOF, 10-3, 10-6 bit
error rate, Loss of each E1 tributary signal and Ethernet status. Since some overhead bytes are taken as
monitoring channel, all alarm and status of Remote can be display locally.

sales@upcomnet.com 1 www.upcomnet.com
HPOM-8E1-4ETH provides RS232 interface for Network Management. Supported by GUI NMS utility, users
can observe the status of Local and Remote, as well as other alarm information unable to be displayed by
LEDs in the front panel. Also, with NMS software, user can make certain E1 loop back for testing purpose, 4 *
10/100 Ethernet ports support intelligent Layer 2 switch features, such as QoS, dot1Q and port based VLAN's,
flow control per port with steps n*32 Kbit/s and more.

 Specification
Optical interface

Line mode type CMI

Bit rate 150Mb/s±50ppm

Wavelength Multi-mode: 850/1310nm, Single-mode :20/40/60/80/120 Km

Optical output power -2~-11dBm

Sensitivity > -36dBm

Dynamic Range 34dB

Connector FC/SC

E1 interface

Channel capacity 8 Channels

Bit rate 2.048Mb/s±50ppm

Code format HDB3

Impedance 75 Ohm BNC and 120 Ohm RJ45

Pulse Shape ITU-T G.703

Jitter Performance ITU-T G.823

Clock mode Internal-clock, external-clock

Ethernet interface

Interface Rate 10/100BaseTx

Duplex Half/full duplex

Interface character IEEE802.3U, IEEE802.3x, IEEE802.1Q

Connector RJ45

Physical

Dimension 483mm*44mm*200mm(width*height*depth)

Weight 5kg

Power consumption 5W

Power supply DC 48V or AC96 -260V or DC&AC dual power

Operating temperature 0-50oC

Storage temperature -40-70oC

Humidity 5%~95% (non-condensing)

sales@upcomnet.com 2 www.upcomnet.com
 Dimension

 Application

sales@upcomnet.com 3 www.upcomnet.com
 Ordering Information
Model NO. Description
HPOM-4E1-4ETH 4E1 (75ohm&120ohm)+4*100M T(x) ,1+1 optical, FC/SC with RS232 GUI,AC220&DC48V

HPOM-8E1-4ETH 8E1 (75ohm&120ohm)+4*100M T(x) ,1+1 optical, FC/SC with RS232 GUI,AC220&DC48V

HPOM-16E1-4ETH 16E1 (75ohm or 120ohm)+4*100M T(x) ,1+1 optical, FC/SC with RS232 GUI,AC220&DC48V

 Packing List
● 8E1+ 4ETH PDH Optical Multiplexer *1
● User manual * 1
● Certificate of quality * 1
● Power cord*1
● Two plugs for Coaxial Cable
● Warranty card * 1

sales@upcomnet.com 4 www.upcomnet.com

You might also like