LDX-3319DS-VTM | LDX-3319DS-A1M
2-port sector antenna, 2x 790–960 MHz, 33° HPBW, RET
compatible
Narrow horizontal beamwidth ideal for corridor coverage or six sector solutions
Azimuth sidelobe suppression greater than 18 dB
General Specifications
Antenna Type Sector
Band Single band
Color Light gray
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage
Radome Material Fiberglass, UV resistant
Radiator Material Aluminum
RF Connector Interface 7-16 DIN Female
RF Connector Location Bottom
RF Connector Quantity, low band 2
RF Connector Quantity, total 2
Remote Electrical Tilt (RET) Information, General
Model with Factory Installed AISG 2.0 Actuator LDX-3319DS-A1M
Dimensions
Width 591 mm | 23.268 in
Length 2581 mm | 101.614 in
Depth 182 mm | 7.165 in
Array Layout
Page 1 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 9, 2020
LDX-3319DS-VTM | LDX-3319DS-A1M
Electrical Specifications
Impedance 50 ohm
Operating Frequency Band 790 – 960 MHz
Polarization ±45°
Electrical Specifications
Frequency Band, MHz 790–806 806–896 870–960
Gain, dBi 19.4 19.8 20.5
Beamwidth, Horizontal, degrees 35 35 34
Beamwidth, Vertical, degrees 7.9 7.5 7.1
Beam Tilt, degrees 0–8 0–8 0–8
USLS (First Lobe), dB 14 15 14
Page 2 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 9, 2020
LDX-3319DS-VTM | LDX-3319DS-A1M
Front-to-Back Ratio at 180°, dB 31 33 35
Isolation, Cross Polarization, dB 27 30 30
VSWR | Return loss, dB 1.4 | 15.6 1.4 | 15.6 1.4 | 15.6
PIM, 3rd Order, 2 x 20 W, dBc -153 -153 -153
Input Power per Port, maximum, watts 300 300 300
Electrical Specifications, BASTA
Frequency Band, MHz 790–806 806–896 870–960
Gain by all Beam Tilts, average, dBi 19.4 19.6 19.9
Gain by all Beam Tilts Tolerance, dB ±0.2 ±0.3 ±0.4
Gain by Beam Tilt, average, dBi 0 ° | 19.2 0 ° | 19.5 0 ° | 19.8
4 ° | 19.4 4 ° | 19.6 4 ° | 20.0
8 ° | 19.3 8 ° | 19.6 8 ° | 19.9
Beamwidth, Horizontal Tolerance, degrees ±1.7 ±1.1 ±1.1
Beamwidth, Vertical Tolerance, degrees ±0.2 ±0.4 ±0.3
USLS, beampeak to 20° above beampeak, dB 14 14 15
Front-to-Back Total Power at 180° ± 30°, dB 27 30 31
CPR at Boresight, dB 20 17 15
Mechanical Specifications
Wind Loading at Velocity, frontal 1,149.0 N @ 150 km/h | 258.3 lbf @ 150 km/h
Wind Loading at Velocity, lateral 230.0 N @ 150 km/h | 51.7 lbf @ 150 km/h
Wind Speed, maximum 241 km/h | 149.75 mph
Packaging and Weights
Width, packed 782 mm | 30.787 in
Depth, packed 346 mm | 13.622 in
Length, packed 3020 mm | 118.898 in
Net Weight, without mounting kit 29 kg | 63.934 lb
Weight, gross 50.5 kg | 111.333 lb
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
Page 3 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 9, 2020
LDX-3319DS-VTM | LDX-3319DS-A1M
ROHS Compliant
Included Products
BSAMNT- — Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top
3 bracket set and one bottom bracket set.
BSAMNT- Middle Downtilt Mounting Kit for Long Antennas for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one
—
M scissor bracket set.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 4 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 9, 2020
BSAMNT-3
Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115
mm) OD round members. Kit contains one scissor top bracket set
and one bottom bracket set.
General Specifications
Application Outdoor
Color Silver
Dimensions
Compatible Diameter, maximum 114.3 mm | 4.5 in
Compatible Diameter, minimum 61 mm | 2.402 in
Material Specifications
Material Type Galvanized steel
Packaging and Weights
Included Brackets | Hardware
Packaging quantity 1
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
Page 5 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 9, 2020
BSAMNT-M
Middle Downtilt Mounting Kit for Long Antennas for 2.4 - 4.5 in (60
- 115 mm) OD round members. Kit contains one scissor bracket set.
General Specifications
Application Outdoor
Color Silver
Dimensions
Compatible Diameter, maximum 114.3 mm | 4.5 in
Compatible Diameter, minimum 61 mm | 2.402 in
Material Specifications
Material Type Galvanized steel
Packaging and Weights
Included Brackets | Hardware
Packaging quantity 1
Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
Page 6 of 6
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 9, 2020
