11546 86-89 NISSAN STANZA 4WD WAGON
3/31/2010
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: 1,500 LBS. TRAILER WEIGHT & 150 LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY 18050 STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
Parts List
ITEM QTY PART NUMBER DESCRIPTION
1 2 1/2-13 x 1 3/4 HEX BOLT
2 2 HFN 1213 HEX FLANGE NUT STEEL
BUMPER BEAM
3 4 HFN3816 HEX FLANGE NUT
PASSENGER SIDE
4 2 CM-SP34 .188 x 1.50 x 3.00" ROUND HOLE SPACER
FRAME RAIL
5 2 CM-11546-BPWA BOLT PLATE WELDMENT ASSEMBLY
DRILL
HOLES
DRIVER SIDE
FRAME RAIL
2
4
3
TIE DOWN BRACKETS
HITCH WEIGHT: 17 LBS.
INSTALL TIME
PROFESSIONAL: 30 MINUTES
NOVICE (DIY): 60 MINUTES
INSTALL NOTES:
- DRILLING REQUIRED
- FASCIA TRIMMIMG REQUIRED
INSTALLATION STEPS
1. Position the hitch on the vehicle with side plates against the outside of the vehicle's (2) tie down brackets.
Loosely install fasteners as shown.
2. Trim the bumper fascia to allow the hitch bumper bracket to sit on the bottom surface of the steel inner
bumper. Using hitch as a template, mark and drill bumper (4) places for 3/8" bolts.
3. Lower the hitch and place bolt plates (CM-11546-BPWA) inside the steel bumper so that the bolts extend
out of the bottom. Mount the hitch on these bolts using fasteners as shown.
4. Torque all 3/8" fasteners to 30 lb-ft, and all 1/2" fasteners to 75 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
217248
