User’s Manual
Model : SS-60WM
Features of product ---
Aluminum Frame
Interface: Support SATA-I, SATA-II
Form Factor: 1 x 5.25” Bay for 6 x 2.5” SATA Hard Disk Driver
Support 2.5” HDD height up to 9.5 mm in height.
High performance transfer rate up to SATA 1.5Gb/s、SATA 3Gb/s、SATA 6Gb/s
Support RAID Functions (*Note : Need an extra SATA Raid Control Card)
Plug & play, hot swappable
With 4Pin Power and 7 Pin data signal connectors
Built-in 2 X 4cm(4020) cooling fan
Twin color LED indication for power on & HDD accessing
Color : black
Dim: 172(L) X 146(W) X 42(H) mm
● Weight: 0.78KG
Mobile Backplane
--Inner tray with heat dissipation holes--
Picture A
There are four screw holes at the bottom of each tray, use the screws (provided) to mount the
HDD on the tray. (See Picture A)
---Safety Lock---
The mechanical lock design keeps the HDD inside the frame and prevents it being taken
out while HDD is working. (See Picture B1 & B2)
a) OPEN
Press and push on the ‘arrow’ position rightward to open each HDD tray( see picture B-1)
b) LOCK
After HDD installed on the HDD tray, slide it into the frame and press the front handle
forward to lock the HDD tray on the frame( See picture B-2).
---Front Panel & Real View--- (See Picture C & D)
Picture C
C1—C6: HDD Tray C8: HDD tray locker.
C7: LED indication ( Blue: Power on. Accessing: Purple)
* Note: When the HDD is installed but it is not powered on, there is no LED indication.
D1: 4pin Power connector D2 – D3: Cooling fan
D4 – D9 : SATA 7pin data port connectors D10: HDD LED Switch( enable/disable )
HDD LED Switch Indication description:
(a) When it is set to “ × “ position, the front LED does NOT light on or blinking while it is accessing [ In this case, the
HDD will spin up when the system power is turned on ].
(b) When it is set to “ ○” position, it is lit on blue blinking while the HDD is being accessing. [ In this case, theHDD
does not spin up until the SATA initial signal is received ].
(c) The default setting for D10 (HDD LED Switch) is to “○” position (HDD LED Enable).
