प्रदे श लोक सेवा आयोग,लुम्बिनि प्रदे श

इम्जिनियरिङ्ग सेवा, नसनिल समूह, सहायकस्ति पााँचौ तह, सव-इम्जिनियि पदको खुल्ला
प्रनतयोनगतात्मक नलम्खत पिीक्षा ।
नमनतिः २०८१।०१।०३
KEY [A]
चरणः प्रथम समयः $% ममनेट पूणणाङ्कः १००
मिषयः सेिण सम्बन्धी
उििपुम्स्तकामा प्रश्नपत्रको KEY अनिवाया रुपले उल्लेख गिुप
ा िेछ । KEY उल्लेख िगिे मा उििपुम्स्तका िद्द
हुिेछ । पिीक्षामा calculator, mobile प्रयोग गिा पाइिेछैि । प्रत्येक खण्डको उिि छु ट्टाछु ट्टै
ु िेछ अजयथा उििपुम्स्तका िद्द हुिछ
उििपुम्स्तकामा लेख्नप े ।

1. कायाालयमा अजयत्रवाट आएका पत्रहरुको फाइनलङ साँग सबिम्जित काम कसको हो ?

A. सोिपुछ शाखा
B. प्रशासि शाखा
C. दताा चलािी शाखा
D. योििा शाखा
2. महत्वपूर्ा ववषयमा अनिकािीिाट निर्ाय गिाउिुलाई के िनिजछ ?
A. प्रनतवेदि
B. तोकआदे श
C. वटप्पर्ी
D. परिपत्र
3. कुि पत्रमा हस्ताक्षि/छाप अनिवाया रुपमा हुाँदैि ?
A. Government letter (सिकािी पत्र)
B. Business letter (व्यावसावयक पत्र)
C. Application form (आवेदि पत्र)
D. Personal letter (व्यम्िगत पत्र)
4. सिकािी ििेटको उदे श्य कुि हो ?
A. Control over the government
B. Implementation of periodic plan
C. Capital formation
D. All of the above
5. सावािनिक सेवा प्रवाहमा Smilling Movement कुि दे शको अनियाि हो ?
A. कताि
B. मलेनसया
C. िापाि

Contact No: 9845682664 1

Innovative
 D. अष्ट्रेनलया
6. Which of the following methods is suitable for plane table surveying a
township where clearings are rare and distant views are seldom
available?
A. Resection method
B. Radiation method
C. Intersection method
D. Traversing method
7. The lines joining points of equal dip are called
A. Aclinic lines
B. Isogonic lines
C. Agonic lines
D. Isoclinic lines
8. The optical square is used to measure angles by
A. refraction
B. reflection
C. double refraction
D. double reflection
Hints:
➢ An optical square is used for setting out right angles. It consists of a
small circular metal box of diameter 5 cm and depth 1.25 cm. It has a
metal cover that slides around the box to cover the slits.
❖ Principle of optical square: According to the principle of reflecting
surfaces, the angle between the first incident ray and the last reflected
ray is twice the angle between the mirrors. In this case, the angle
between the mirrors is fixed at 45˚. So, the angle between the horizon
sight and index sight will be 90˚.
9. The traversing by the method of deflection angles is chiefly used in
A. canals
B. highways
C. railways
D. all of these
10. The clay to be used for manufacturing bricks for a large project, is
dugout and allowed to weather throughout.
A. the monsoon
B. the winter
C. the summer
D. none of these
11. Resins are.
A. not soluble in water
B. soluble in spirit
C. used in varnishes
D. left behind on evaporation of oil

Contact No: 9845682664 2

Innovative
 12. For the manufacture of stainless steel, steel is mixed with.
A. chromium
B. nickel
C. tungsten
D. none
13. The cement becomes unsound by the presence of excess.
A. sulphur
B. magnesia
C. lime
D. All of these
14. The ratio of elongations of a prismatic bar due to its own weight and
that of a conical bar of the same length, is
A. 1/2
B. 1/3
C. 3
D. 2
15. A simply supported beam of span L carries a concentrated load W at
its mid-span. The maximum bending moment M is
A. WL/2
B. WL/4
C. WL/8
D. WL/12
16. Stream lines and path lines always coincide in case of
A. steady flow
B. laminar flow
C. uniform flow
D. turbulent flow
17. Liquids
A. Have no shape
B. Can not be compressed
C. Both (A) and (B)
D. None of the above
18. For a turbulent flow, the Reynold's number should be more than
A. 4000
B. 2700
C. 2000
D. 500
19. The pitot tube is used to measure.
A. velocity at stagnation point
B. stagnation pressure
C. Static pressure
D. Dynamic pressure
20. Over-consolidation of soils is caused due to

Contact No: 9845682664 3

Innovative
 A. erosion of over burden
B. melting of ice sheets after glaciation
C. permanent rise of water table
D. none of the above
21. Darcy's law is applicable to seepage if a soil is
A. Homogeneous
B. isotropic
C. Incompressible
D. all the above
22. Depending upon the properties of a material, the failure envelope
may
A. be either straight or curved
B. pass through the origin of stress
C. intersect the shear stress axis
D. all the above
23. Rankine’s theory of earth pressure assumes that the back of the wall
is
A. plane and smooth
B. plane and rough
C. vertical and smooth
D. vertical and rough
24. The approximate value of the ratio between direct tensile strength
and flexural strength is.
A. 0.33
B. 0.5
C. 0.75
D. 1.0
25. For a reinforced concrete section, the shape of shear stress diagram
is
A. wholly parabolic
B. wholly rectangular
C. parabolic above neutral axis and rectangular below neutral axis
D. rectangular above neutral axis and parabolic below neutral axis
26. The factor of safety for
A. Steel and concrete are same
B. Steel is lower than that for concrete
C. Steel is higher than that for concrete
D. None of the above
27. Which of the following type of foundation is used for the construction
of building on black cotton soil?
A. Grillage foundation
B. Inverted arch foundation

Contact No: 9845682664 4

Innovative
 C. Floating foundation
D. Mat foundation
28. The temporary framework is known as __________ and it is useful in
construction demolition, maintenance or repair works.
A. Grouting
B. Scaffolding
C. Shoring
D. Underpinning
29. In which of the following type of construction, the square or
rectangular blocks of stones are used?
A. Rubble masonry
B. Rock Masonry
C. Ashlar masonry
D. Brick masonry
30. Which of the following is known as washout valve?
A. Scour valve
B. Sluice valve
C. Reflux valve
D. Altitude valve
Hints:
➢ Scour valve is known as washout valve. They are either located at the
dead ends or at the lowest point in the mains.
➢ Reflux valve is known as non-return valve or check valve. They are
placed in water pipes which obtain water directly from the pumps.
31. The minimum width of a septic tank is taken
A. 70 cm
B. 75 cm
C. 80 cm
D. 90 cm
32. The effluent of a septic tank is
A. Fit for discharge into any open drain
B. Foul and contains dissolved and suspended solids
C. As good as that from a complete treatment
D. None of these
33. Maximum consumption of water is noticed in
A. Paper industry
B. Steel plant
C. Automobile industry
D. Foundry
34. Run off can be estimated by
A. Infiltration method
B. Unit hydrograph

Contact No: 9845682664 5

Innovative
 C. Rational method
D. Any of the above
35. Water-shed line is abondened for aligning an irrigation canal if.
A. water shed forms a sharp loop
B. canal has to take off from a river
C. towns and villages are located on the water shed line
D. all the above
36. Permanent canals run
A. Perennially
B. Intermittently
C. Don't run at all
D. Both (A) and (B)
37. Disposal of extra excavated earth of canals, is utilised to provide a
spoil bank on.
A. left side
B. right side
C. both sides
D. all the above
38. When a canal and a drainage approach each other at the same level,
the structure so provided, is.
A. an aqueduct
B. a syphon
C. a level crossing
D. inlet and outlet
39. For standing crops in undulating sandy fields, the best method of
irrigation, is.
A. sprinkler irrigation
B. free flooding
C. check method
D. furrow method
40. The length of valley curve depends on
A. Speed limit
B. deviation angle
C. Centrifugal acceleration
D. Speed limit and deviation angle
41. What is the minimum setback?
A. 0.4 m
B. 0.2 m
C. 3.0 m
D. 5.0 m
42. The vertical alignment of a highway includes?
A. Highway lighting
B. Design of valley curves and gradients

Contact No: 9845682664 6

Innovative
 C. Sight distance and traffic intersection
D. Widening of pavements
43. What is the first step in highway construction after paperwork?
A. Evaluation
B. Bill of quantities
C. Surveying
D. Estimation
44. What is the most important structure in a hill road?
A. Retaining wall
B. Pavement
C. Drainage
D. Security force
45. Quality control is done by
A. Engineer
B. contractor
C. Supervisor
D. owner
46. Which of the following is not a part of bidding document?
A. Invitation to bidders
B. Instruction to bidders
C. BOQ
D. None of the above
47. The money of the contractor retained by the department during
payments is called:
A. tender money
B. retention money
C. earnest money
D. security money
48. A semi-corrugated or Trafford sheet has a standard width of
A. 0.9 m
B. 1 m
C. 1.05 m
D. 1.10 m
49. Generally the provision for supervision is
A. 0.01
B. 2 to 3%
C. 3 to 5%
D. 5 to 10%
50. The unit of measurement of stone dust is
A. Cu. m
B. Sq. m

Contact No: 9845682664 7

Innovative
 C. R. m
D. Kg

<<Good Luck<<

Contact No: 9845682664 8

Innovative