RVV2NPX310.
211R
10-port sector antenna, 2x 694–960 MHz 65° HPBW, 4x 1695-2690
MHz 65° HPBW and 2x 1695-2180 MHz 2x 33° HPBW, 5x RET with
manual override. Bands cascaded SRET
Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt with
manual override on all arrays
All Internal RET actuators are connected in “Cascaded SRET” configuration
Alternative products available:
RVV2H-6533D-R5 10-port sector antenna, 2x 694–960 and 4x 1695-2690 MHz 65° HPBW and 4x 1695-2180 MHz 2x 33°
HPBW, 5x RET.
General Specifications
Antenna Type Sector
Band Multiband
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN
Radome Material Fiberglass, UV resistant
Radiator Material Low loss circuit board
Reflector Material Aluminum
RF Connector Interface 7-16 DIN Female
RF Connector Location Bottom
RF Connector Quantity, high band 8
RF Connector Quantity, low band 2
RF Connector Quantity, total 10
Remote Electrical Tilt (RET) Information
RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 1 female | 1 male
Input Voltage 10–30 Vdc
Internal RET High band (4) | Low band (1)
2W Page 1 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 9, 2024
RVV2NPX310.211R
Power Consumption, idle state, maximum 2W
Power Consumption, normal conditions, maximum 13 W
Protocol 3GPP/AISG 2.0 (Single RET)
Dimensions
Width 350 mm | 13.78 in
Depth 208 mm | 8.189 in
Length 2,763.5 mm | 108.799 in
Net Weight, without mounting kit 46.1 kg | 101.633 lb
Array Layout
Port Configuration
Page 2 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 9, 2024
RVV2NPX310.211R
Electrical Specifications
Impedance 50 ohm
Operating Frequency Band 1695 – 2180 MHz | 1695 – 2690 MHz | 694 – 960 MHz
Polarization ±45°
Electrical Specifications
LB LB LB HB HB HB HB-Dual-Beam2HB-Dual-Beam2
Frequency Band, MHz 694–790 790–890 890–960 1695–1920 1920–2180 2300–2690 1695–1920 1920–2180
Gain, dBi 16.2 16.5 16.7 17.5 18.2 18.8 17.2 18.8
Beam Centers, Horizontal, ±31 ±28
degrees
Beamwidth, Horizontal, 69 68 68 62 62 61 36 32
degrees
Beamwidth, Vertical, 10.1 8.9 8.3 7.5 6.7 5.5 7.7 6.9
degrees
Beam Tilt, degrees 0–10 0–10 0–10 0–10 0–10 0–10 0–10 0–10
USLS (First Lobe), dB 18 18 18 18 18 18 18 18
Null Fill, dB -22 -22 -22 -22 -22 -22 -22 -22
Front-to-Back Ratio at 31 33 34 35 38 38 28 33
180°, dB
27 27 27 27 27 29 24 27 Page 3 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 9, 2024
RVV2NPX310.211R
Front-to-Back Total Power 27 27 27 27 27 29 24 27
at 180° ± 30°, dB
Isolation, Cross 28 28 28 30 30 30 25 25
Polarization, dB
Isolation, Beam to Beam, 18 18
dB
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.43 | 15.0 1.43 | 15.0
PIM, 3rd Order, 2 x 20 W, -150 -150 -150 -150 -150 -150 -150 -150
dBc
Input Power per Port, 300 300 300 250 250 250 250 250
maximum, watts
Mechanical Specifications
Wind Loading @ Velocity, frontal 493.0 N @ 150 km/h (110.8 lbf @ 150 km/h)
Wind Loading @ Velocity, lateral 423.0 N @ 150 km/h (95.1 lbf @ 150 km/h)
Wind Loading @ Velocity, maximum 1,044.0 N @ 150 km/h (234.7 lbf @ 150 km/h)
Wind Loading @ Velocity, rear 523.0 N @ 150 km/h (117.6 lbf @ 150 km/h)
Wind Speed, maximum 241 km/h (150 mph)
Packaging and Weights
Width, packed 436 mm | 17.165 in
Depth, packed 320 mm | 12.598 in
Length, packed 2985 mm | 117.52 in
Weight, gross 68.5 kg | 151.016 lb
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Above maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
ROHS Compliant/Exempted
UK-ROHS Compliant
Included Products
T-029-GL-E – Adjustable Tilt Pipe Mounting Kit for 2.362"-4.5" (60-115mm) OD round members for panel
Page 4 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 9, 2024
RVV2NPX310.211R
antennas. Includes 2 clamp sets.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 5 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 9, 2024
T-029-GL-E
Adjustable Tilt Pipe Mounting Kit for 2.362"-4.5" (60-115mm) OD round
members for panel antennas. Includes 2 clamp sets.
Product Classification
Product Type Adjustable tilt mounting kit
General Specifications
Application Outdoor
Color Silver
Dimensions
Compatible Length, maximum 2850 mm | 112.205 in
Compatible Length, minimum 1500 mm | 59.055 in
Compatible Diameter, maximum 115 mm | 4.528 in
Compatible Diameter, minimum 60 mm | 2.362 in
Antenna-to-Pipe Distance 85 mm | 3.346 in
Bracket-to-Bracket Distance 1400 mm | 55.118 in
Weight, net 6 kg | 13.228 lb
Material Specifications
Material Type Galvanized steel
Mechanical Specifications
Mechanical Tilt 0°–8°
Packaging and Weights
Included Brackets | Hardware
Packaging quantity 1
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
Page 6 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 6, 2024
T-029-GL-E
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
UK-ROHS Compliant
Page 7 of 7
©2024 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: September 6, 2024
