Dental Fluorosis
Definition:
• Developmental disturbance. Not a disease but rather affects the
way that teeth look.Dental fluorosis is a defect of the teeth marked
by increased porosity of the enamel ( a condition known as
“Hypomineralization“ or enamel mottling ) .
• This defect of tooth enamel caused by too much fluoride intake
during the first 8 years of life. the damage to the enamel is
permanent. The fluorosis of primary tooth enamel is very rare.
Mechanism of action of fluoride
• Teeth are generally composed of hydrooxyapatite and Carbonated Hydro
oxyapatite ; as the intake of fluoride increases , so does the teeth's
composition of fluroapatite.
• Structurally, an increase in fluoride intake results in an increase in degree
and extent of porosity of the enamel ; the enamel changes described may
be a result of a fluoride damage of secretory ameloblasts .
• This can either be due to a fluoride-induced change in composition of
enamel matrix, or be a result of a disturbance of the cellular processes
during enamel maturation.
Causes of fluorosis include
• Excess fluoridation of drinking water.
• Inappropriate use of fluoride containing dental products such as
Toothpastes and mouth rinses.
• Consumption of processed food made with fluoridated water.
• taking a higher-than-prescribed amount of a fluoride supplement
during early childhood ( As use overuse of Fluoride tablets(.
• taking a fluoride supplement when fluoridated drinking water or
fluoride fortified fruit juices and soft drink already provide the right
amount.
Optimal Level of Fluoride and Fluorosis
• 1 ppm → minimal threshold of fluorosis
.When fluoride concentration is more than 1
ppm undesirable mottling began to be seen in
about 10% of the population.
Variables Affecting Prevalence and
Severity of Dental Fluorosis
• Fluoride concentration in drinking water:
• when increase lead to increase in dental
fluorosis.
• Total amount of fluoride ingested:
• which include amount of fluoride in water,
food, drugs, dentifrices…..etc.
• Temperature:
• water requirement increase in hot
temperature which increase possibility of
fluorosis. Studies showed that there are more
dental fluorosis in tropical climate than
temperate climate.
• Duration of exposure:
• fluorosis increased with the longer time teeth
are exposed to fluoride.
• Malnutrition:
• in some studies showed that malnourished
children develop more dental fluorosis than
well-nourished and it is still not well
understood.
• Degrees of dental fluorosis:
• Very mild to mild(slight mottling of teeth)
Chalk like discoloration of teeth with white
spot or lines on tooth enamel.
• Moderate (obvious mottling of teeth) yellow
or brown discoloration.
• Severe (severe mottling of teeth) pitted tooth
surface Symptoms.
Dental fluorosis index
• Dean‘s Index – 1934
• Dean’s 0 Normal: The enamel surface is smooth, glossy
and usually a pale creamy-white color.
• Dean’s 1 Questionable: The enamel shows slight
aberrations from the translucency of normal enamel,
which may range which may range from a few white
flecks to occasional spots.
• Dean’s 2 Very mild: small opaque white area scattered
irregularly over the tooth, but not involving more than
25% of the tooth surface, for posterior teeth it is an
area of 1 – 2 mm white opaque area at the tips of the
cusps of molars and premolars.
• Dean’s 3 Mild: we have white opaque area in the
enamel more extensive than for code 2 but involving
not more than 50% of the tooth surface.
• Dean’s 4 Moderate: all enamel surface are effected,
surfaces are subjected to attrition, it showed there is a
marked wear brown stain.
• Dean’s 5 Severe: when the all enamel surface are badly
affected and the hypoplasia is so marked that the
general form of the tooth may be affected, There are
pitted or worn areas and brown stains are widespread;
the teeth often have a corroded appearance.
• Code 6 : All 4 anterior teeth absent.
Enamel Mottling by AL – Alousi et al . (1975)
• Selection of teeth and scoring:
• Labial surface of permanent incisor teeth .
Calculation of the prevalence of different
types of opacities in both individual and teeth
.
Diagnosis and criteria
• Type A : White area less than 2 mm in diameter .
• Type B : White area of , or greater than 2 mm in
diameter .
• Type C : Colourd (brown) area less than 2 mm in
diameter, irrespective of there being white area.
• Type D : Colourd (brown) area of, or greater than 2 mm
in diameter, irrespective of there being any white area.
• Type E : Horizontal white lines , irrespective of there
being any white non-linear lines.
• Type F : Colourd (brown) or White area or lines
associated with pits or hypoplastic area.
