©2023 TVET CDACC
071306T4EEN
Electrical Engineering (Power Option) Level 6
ENG/CU/PO/CR/02/6
Install Electrical Power Lines
July/August 2023
TVET CURRICULUM DEVELOPMENT, ASSESSMENT AND CERTIFICATION
COUNCIL (TVET CDACC)
om
t.c
ve
t
sy
ea
INSTRUCTIONS TO THE ASSESSOR
1. You are required to mark the practical as the candidate performs the tasks.
2. You are required to take video clips at critical points.
3. Ensure the candidate has a name tag and registration code at the back and front.
4. Ensure at all times that the candidate is performing tasks in a safe environment
This paper consists of four (5) printed pages.
Assessor should check the tool to ascertain that all the pages are printed as indicated and
that no question is missing.
1 of 5
©2023 TVET CDACC
Candidate’s name & Registration No.
Assessor’s name & Reg. code
Unit(s) of Competency
Venue of Assessment
Date of assessment
Items to be evaluated: Marks Marks
Comments
(Award marks as appropriate for each item evaluated) available obtained
OBSERVATION CHECKLIST
1. Wore safety clothing
i. Safety boots (Award 1 or 0) 1
ii. Apron (Award 1 or 0) 1
iii. Proper handling of tools (Award 1 or 0) 1
om
.c
t
2. Observed colour code (Award 1 or 0) 1
t ve
sy
ea
Sub Total 4
PRODUCT CHECKLIST
1 2
3. Listed tools to be used (award any 4× 2)
4. Listed materials used (award any 4× 1) 4
Sub-total 6
5. Correct circuit diagrams
Single phase (Award 5 or 0 marks)
10
three phase (Award 5 or 0 marks)
6. Installed the circuit using provided materials
i. Fixed components firm and level
(award 5× 1) 5
2 of 5
©2023 TVET CDACC
ii. cable runs
Vertical and flat on the surface(award 2× 1 2
Horizontal and flat on the surface
2
(award 2× 1)
iii. Correct cable choices (award 2 or 0) 2
7. Neatness (award 2 or 0) 2
Sub-total 23
8. Termination of
i. Surge arresters
ii. Ball spikes 8
iii. 3 phase energy meter
iv. MCBs
om
.c
(award 2 or 0 for each))
t
ve
9. Correct circuit operation
t
sy
Excess voltage suppressed (award 10 or
ea
0) 10
Sub-total 18
10. Performed housekeeping (award 2 or 0) 2
Sub-total 2
11. Performed the following tests
Resistance test (award 2 or 0)
2
Continuity test (award 2 or 0)
2
3 of 5
©2023 TVET CDACC
Sub-total 4
Total marks 57
The candidate was found to be: (Please tick (√) as appropriate)
Competent Not yet competent
(The candidate is competent if the candidate scores 50% and above)
Feedback from candidate:
Feedback to candidate:
Candidate’s signature: Date:
Assessor’s signature: Date:
om
t .c
ve
List of tools
t
sy
ea
i. Neon tester
ii. Combinational pliers
iii. Side cutter
iv. Set of screw driver
v. Ball peen hammer
vi. Tape measure
List of materials
i. Metal rod
ii. Plate
iii. Surge protector
iv. 3 phase MCB
v. lightning spike ball/receiver
vi. Grounding clamp
vii. Mounting hardware (brackets, rails, clips,)
viii. 3 phase energy meter
4 of 5
©2023 TVET CDACC
ix. Conductors
x. Wood Screws
xi. Circuit connecting wires
Wiring diagram
om
t.c
ve
t
sy
ea
THIS IS THE LAST PRINTED PAGE
5 of 5
