Scribd
Upload
200 views3 pages

New Control Box Iveco Engine

The document outlines the hardware specifications for the IVECO Generic Interface Module, detailing the various controller outputs, inputs, power inputs, and engine outputs. It includes descriptions of signals, types, and jumper settings for configuration. Additionally, it specifies switch positions for different operational modes.

Uploaded by

zawmintun zpe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
200 views3 pages

New Control Box Iveco Engine

The document outlines the hardware specifications for the IVECO Generic Interface Module, detailing the various controller outputs, inputs, power inputs, and engine outputs. It includes descriptions of signals, types, and jumper settings for configuration. Additionally, it specifies switch positions for different operational modes.

Uploaded by

zawmintun zpe
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Rev.

0 10/2010

HARDWARE SPECIFICATIONS
Document: IVECO Generic Interface Module Specifications MIHI0100.20
File: Hardware Description MIHI0100.20.odt
Reference: MIHIEH00.20 Original Date: 02/11/11
Review: 1 Review Date: 02/11/11
Prepared by: Aitor Ubierna Reviewed by:

CN1: Controller output

SIGNAL DESCRIPTION TYPE


NA Water level alarm Digital output NPN
NC Fuel Level Analog Output
PAC Water in fuel alarm Digital output NPN
RC Fuel reserve warning Digital output NPN
BPA Low oil pressure alarm Digital output NPN
ATA High water temperature alarm Digital output NPN

CN2: Controller inputs / Bus communications

SIGNAL DESCRIPTION TYPE


JS BUS cable Shielding CAN BUS
CAN L Line Bus J1939 CAN BUS
CAN H Line Bus H J1939 CAN BUS
D+ Alternator excitation signal INPUT PNP
In +15 Start-Stop signal INPUT PNP
ARR_IN Engine start signal INPUT PNP

CN3: Power input and Preheating

SIGNAL DESCRIPTION TYPE


+ BAT Power Battery Positive Out
-BAT Power Battery Negative Out
PR Preheating In

CN4: Power input from battery

SIGNAL DESCRIPTION TYPE


+ BAT Battery positive In
-BAT Battery Negative In

CN5: Engines output


SIGNAL DESCRIPTION TYPE
ARR Starter motor Driver output 70A
CALC Fuel heating Driver output 70A
PR Preheat Bypass Output PNP

CN6: Engine Outputs

SIGNAL PIN ECU PIN ECU DESCRIPTION TYPE


NEF CURSOR
+15 39 40 Configurable output (+15) Driver output 70A
D+ Bypass Output PNP
BAT+ 1 2 ECU Battery Positive Power
BAT+ 7 3 ECU Battery Positive Power
BAT+ 12 8 ECU Battery Positive Power
BAT+ 13 9 ECU Battery Positive Power

JUMPERS DESCRIPTION

Name Position 1-2 Position 2-3 Default position


JP1 Preheating no connected Preheating connected 1-2
JP2 Relay preheating no connected Relay preheating connected 1-2
JP3 CAN termination connected CAN termination no connected 1-2
JP4 Manual Ignition ON OFF Manual Ignition OFF 2-3
JP5 NEF: 50Hz / CURSOR: 60Hz NEF 60Hz / CURSOR 50Hz NEF: 1-2 / CURSOR: 2-3

SWITCHES DESCRIPTION

Switch Position NEF 12/24 Position CURSOR


S1 ↑ ↑
S2 ↓ ↓

You might also like