PROTECTIVE COATINGS DIVISION OF JENSON & NICHOLSON
J & N 996 HB POLYURETHANE FINISH
This is a hard, tough, flexible and abrasion resistant, coating. This has outstanding resistance to
SCOPE broad range of corrosive atmosphere. It has excellent acid, alkali, solvent, water and salt solution
resistance when applied over suitable primer.
1- For all types of structures in fertilizers and chemical plants, paper & pulp plants, off-
platforms, petroleum refineries etc.
TYPICAL USES 2- For concrete structures to resist, corrosive chemicals like acid, alkali, salt solution etc.
3- For structures to resist the river water and sea water.
4- For painting of interior of tanks storing petroleum products and other chemicals.
TYPE Two pack, cold cured
COMPOSITION Acrylic-Aliphatic Polyisocyanate with weather resistant pigments.
COLOUR As per shade card or specified colour
FINISH Semi-glossy to egg shell
SURFACE PREPARATION Steel Surfaces - Degrease and blast clean to Sa 2 1/2 grade minimum
150°C dry heat (intermittent)
TEMPERATURE RESISTANCE
110°C dry heat (sustained)
MIXING RATIO Base : Hardener : 4 : 1 by volume
POT LIFE 3 hours. (at 25°C)
VOLUME SOLID 60 ± 2%
THEORETICAL COVERAGE 7.2 - 7.6 sqm / ltr. At 80 microns dry film thickness.
DRY FILM THICKNESS 60-80 microns / coat
Use airless spray . Brush recommended for small areas . Care must be taken to acheive the
APPLICATION METHODS
specified dry film thickness.
Touch dry : 6 hours
DRYING TIME Hard dry : 18 hours
RECOATABILITY TIME Overcoat : 24 hours
Full cure : 7 days
Epilac Primers of J & N Inorganic Zinc primer or Epilac 976-SP
RECOMMENDED PRIMERS
Coating or J & N Polyurethane Primers or as recommended.
SOLVENT J & N PU Thinner 907/101
FLASH POINT Above 20°C.
STORAGE & SHELF LIFE 9 months in original sealed container. To store indoors.
General Safety and Environment Information
• Keep container upright and tightly closed in a cool, dry and well ventilated location away from heat source, flammables and direct sunlight.
• Keep out of reach of children. Do not store near food, drinks or animal feed.
• Dispose unwanted paint safely. Do not dispose into drains, water sources or open sewers.
• Wash all tools after application with General Purpose Thinner or Mineral Turpentine.
• Use sand or earth to contain any paint spillage.
• In the case of accidental contact, wash area immediately with water and seek immediate medical attention.
• Wear appropriate attire, especially gloves, eye protection and nose mask.
• Wear appropriate attire, especially gloves, eye protection and nose mask.
• Work in a well-ventilated area. Do not breathe vapour or spray.
• Remove paint from skin by washing with water and soap or appropriate cleaner.
• Avoid contact with skin as it may cause irritation.
• To remove the paint from skin, use soap and water or appropriate cleaner.
*Actual Coverage may vary depending upon the application process and surface conditions.
The information given is intended to give a description of the product performance under specific test conditions. Nevertheless, we cannot assume any responsibility for the use of it since
circumstances under which the products are applied in practice are subjected to many variations. We reserve the right to change the given data without furthur notice.
JENSON & NICHOLSON COLOURS PVT. LTD.
S-2, Okhla Industrial Area, Phase-2, New Delhi- 10020
8851468306 ----sales@jnipaints.com ------sales.jnipaints@gmail.com ------ www.jnipaints.com
