Northrop Grumman B-2 Spirit Bend and glue to

shape (till the

middle "gap" is
tight)
0

0
1

1
2

2
3

3
4 5cm
1:400 scale - print at 100%
1:500 scale - print at 80%
4cm
Print with 100% scale
setting, not "fit to
Left engine
(paint inside face black)
Right engine
(paint inside face black)
Main bomb bay door
(when opened, optional)
paper" setting 1:400
82388

scale @ A4 paper
82388

88

0328
0328
Light green
side glue to SPIRIT SPIRIT

88
wing
OF
TEXAS WM WM OF
TEXAS
When glue to fuselage,
393d TIGERS 393d TIGERS
the sides needs to
gently pushed in and
(< front) Left Right (front > ) up (as indicated by the
arrows).
Bend Bend (optional)
up up Cut landing gear door and/
Fold Fold Fold Fold or bomb bay door at belly
170o 170o 170o 170o for opened position (and
expose wing filler level 2)
When glue to fuselage, align

(1) (1)
this highlighted profile to wing
(between engine exhaust) first .

Bend slightly to
follow contour of
wing fillers

11

9
393d
ERS
393d
TIG WM TIGERS
WM AS TEX
TEXOF IT SPOF AS
SPIR IRIT

(optional)
Cut our landing gear
bay door for "gear
down" position and
expose wing filler
level 2
(optional) (optional)
Cut out this Cut out this
bit to make bit to make
the engine fit the engine fit
tighter to the tighter to the
wing wing

1 3
10
(largest)
(optional)
Fold Cut these black Fold
180o engine exhausts to 180o
form a slight recess
(and expose wing
filler level 12)

Steps:
2 3 5
7
1 - Double the thickness of wing fillers
(numbered 3 to 12) by glueing (at least) another
sheet of paper to their back, glue them all
together.

2 - Cut and fold the main wing (numbered 1 and

13) as per the detailed guidance.

3 - Glue the wing and wing fillers together. Start

(fa
ce
do
4
w

8
at the nose, and make sure it is centred, ie. no n)
wing fillers exposed. Also check for a smooth

6
bottom seam.

4 - Cut, fold, and then glue the engines onto the

wing. Make hard and sharp folds on the engine
sides to make the engine shape flow better with
the wing.
*Note: put extra weight inside nose to
5 - Cut, bend, and then glue the cockpit into ensure balance on wheels with no "tail
strike"

1:400
shape. Glue it onto the wing as per the detailed
guidance.

6- Landing gears, reinforce where needed as

- This is NOT a model
usual. licensed by
manufacturer/ airline
12
little_model_airport