Cisco
300-630Exam
Implementing Cisco Application Centric
Infrastructure - Advanced
Questions & Answers
(Demo Version - Limited Content)
Thank you for Downloading 300-630 exam PDF Demo
Get Full File:
https://www.dumpsvibe.com/cisco/300-630-dumps.html
Questions & Answers PDF Page 12
Version: 5.0
Q uestion: 1
Refer to the exhibit.
How is the ARP request from VM1 forwarded when VM2 is not learned in the Cisco ACI fabric?
A . Leaf 101 forwards the ARP request to one of the proxy VTEP spines.
B . POD1 spine responds to the ARP request after the POD1 COOP is updated with the VM2 location.
C . Leaf 101 encapsulates the ARP request into a multicast packet that is destined to 225.0.37.192.
D . Leaf 101 switch consumes the ARP reply of VM2 to update the local endpoint table.
Answer: A
Q uestion: 2
Which approach does Cisco ACI use to achieve multidestination packet forwarding between leaf
switches in the same fabric?
A. Map VXLAN VTEP to the multicast group
B . Map VXLAN to PIM-SM protocol
C . Map VXLAN VNI to the multicast group
D . Map VXLAN to PIM-DM protocol
www.Dumpsvibe.com
Questions & Answers PDF Page 3
Answer: C
Question: 3
What does the VXLAN source port add to the overlay packet forwarding when it uses the hash of
Layer 2, Layer 3, and Layer 4 headers of the inner packet?
A. ECMP
B. TCP optimization
C. disabled fragmentation
D. jumbo frames
Answer: A
Reference: https://www.cisco.com/c/en/us/support/docs/lan-switching/vlan/212682-virtual-
extensible-lan-and- ethernet-virt.html
Question: 4
Which two actions are the Cisco best practices to configure NIC teaming load balancing for Cisco UCS
B- Series blades that are connected to the Cisco ACI leaf switches? (Choose two.)
A. Create vPC+
B. Enable LACP active mode
C. Create PAgP
D. Create vPC
E. Enable MAC pinning
Answer: BE
Question: 5
www.Dumpsvibe.com
Questions & Answers PDF Page 4
An organization migrates its virtualized servers from a legacy environment to Cisco ACI. VM1 is
incorrectly attached to PortGroup IT|3TierApp|Web. Which action limits IP address learning in BD1?
A. Enable Enforce Subnet Check
B. Enable Rouge Endpoint Control
C. Enable GARP-based EP Move Detection Mode
D. Disable Remote EP Learn
Answer: C
www.Dumpsvibe.com
Thank You for trying 300-630 PDF Demo
https://www.dumpsvibe.com/cisco/300-630-dumps.html
Start Your 300-630 Preparation
[Limited Time Offer] Use Coupon "GET20OFF" for extra
20% discount the purchase of PDF file. Test your 300-630
preparation with actual exam questions
www.Dumpsvibe.com