Havbrise - Bag
No. 1001-202-6913
Materials: Measurements: About 25 cm in
Rainbow 8/8 - col. 73 and 91 diameter, 28 cm tall (laying flat)
Rainbow 8/4 - col. 91 - for straps
Prym “Liv” leather bag base
Crochet hook 3 mm Abbreviations:
Carabiner 48 mm st(s): stitch(es)
Knitting mill
ch: chain stitch
Yarn usage: sc: single crochet
Color A: 110g (3 skeins) hdc: half double crochet
Color B: 80g (2 skeins) b-bl: bottom back loop of stitch
Straps: 20g
sl st: slip stitch
Buy the yarn and accessories here: SPsc: spike stitch
http://shop.hobbii.com/havbrise-bag
Hobbii.com - Copyright © 2020 Page 1
NOTE:
From round 2, every round is started with ch 2. These do not take the place of any
sts, neither do they count towards the st total.
Every round is ended with a sl st from the back into the second ch from the
beginning of the round. This is a regular sl st, but is worked from the back instead of
the front, as usually done. This makes the join between rounds and color changes
less noticeable. The join will still pull a bit and lean to one side, as you are working in
the round. See the guide with pictures at the end of the pattern instructions.
Pattern instructions – Guide with pictures at the end of the instructions
The bag is made using 8/8 cotton yarn.
1. Use color A. Loop the yarn through a st/loop in the edge of the bag base. Ch 1, then
sc into every st/loop around the bag base. Finish round with a sl st. (114)
2. Ch 2. Hcd in every st of the round. End round with a sl st from the back. (114)
3. Switch to color B. Ch 2, then hdc into the b-bl of every st until end of round. Join
round with a sl st from the back. (114)
4. Switch to color A. Ch 2, then hdc into the b-bl of every st until end of round. Join
round with a sl st from the back. (114)
Repeat rounds 3 and 4 until you have 34 rounds in total.
35. Continue in color A. Ch 1, then sc into b-bl of every st of the round. Join round with a
sl st from the back. (114)
36. Ch 1. SPsc into the next 26 sts. SPsc into the next 5 sts, working around a d-ring to
attach it. SPsc into the next 52 sts. SPsc into the next 5 sts, working around another
d-ring to attach it. SPsc into the next 26 sts. Join the round with a sl st. (114)
37. Work sl st into every st of the round. (114) Cut yarn and weave in ends.
Hobbii.com - Copyright © 2020 Page 2
Straps:
Using the knitting mill and the Rainbow 8/4 yarn, make 5 i-cords of about 65 cm each.
Sew them together and attach them as pictured below:
1. Using the knitting mill and the Rainbow 2. Sew the ends of the 5 i-cords together.
8/4 yarn, make 5 i-cords of about 65 cm
each.
3. Thread the cords through the d-ring of 4. Sew the cords around the d-ring.
the carabiner.
Hobbii.com - Copyright © 2020 Page 3
5. Cut the yarn and weave in ends. 6. Repeat the same steps for the other end.
7. Clip the carabiners to the d-rings 8. Like so.
crocheted to the bag.
Hobbii.com - Copyright © 2020 Page 4
Guide:
Round 1
1. Use color A. Loop the yarn through a 2. Ch 1, then sc into every st/loop around
st/loop in the edge of the bag base. the bag base.
3. Finish round with a sl st. (114)
Round 2
1. Ch 2. 2. Hdc in every st of the round.
Hobbii.com - Copyright © 2020 Page 5
3. Join round with a sl st from the back. Lift 4. Catch your loop.
the loop off the hook and thread the hook
through the 2nd ch from the beginning of
the round as shown in the picture.
5. Pull the loop through the st. You have
now made a sl st from the back. (114)
Hobbii.com - Copyright © 2020 Page 6
Round 3
1. Switch to color B. Ch 2. 2. Now make a hdc in the b-bl. The bottom
back loop is the loop that is shown when
you tip your work a bit towards you. It it just
behind the two loops you normally work
through. The needle in the picture shows
where you should make your first hdc.
3. Like so. 4. Make a hdc in the b-bl of the next st.
5. Like so. 6. Repeat this all the way around.
Hobbii.com - Copyright © 2020 Page 7
7. Join your round with a sl st from the back. 8. Catch your loop and pull through the st.
Slip your loop off the hook, thread the hook
from the back through the 2nd ch from the
beginning.
9. Like so. (114)
Round 4
1. Switch to color A. 2. Make a hdc in the b-bl of the first st.
Hobbii.com - Copyright © 2020 Page 8
3. Like so. 4. Repeat the hdc in the b-bl of the sts until
end of round.
5. Join round with a sl st from the back. 6. Like so. (114)
Round 5 to 34
1. Repeat rounds 3 and 4 until you have 34
rounds in total.
Hobbii.com - Copyright © 2020 Page 9
Round 35
1. Continue in color A. Ch 1, 2. then sc into b-bl of every st of the round.
Join round with a sl st from the back. (114).
Round 36
1. Ch 1.
2. SPsc into the next st. A SPsc is a sc that
is worked into the st below the one you
would normally work in. The needle shows
where to work your first SPsc.
Hobbii.com - Copyright © 2020 Page 10
3. Like so. 4. SPsc into the next 25 sts.
5. SPsc into the next 5 sts, working around 6. Like so.
a d-ring to attach it.
7. SPsc into the next 52 sts. 8. SPsc into the next 5 sts, working around
another d-ring to attach it.
Hobbii.com - Copyright © 2020 Page 11
9. Like so. 10. SPsc into the next 26 sts. Join the round
with a sl st. (114).
Round 37
1. Sl st in every sts of the round. (114) 2. Cut yarn and weave in ends.
Hobbii.com - Copyright © 2020 Page 12
Enjoy! :)
Hobbii.com - Copyright © 2020 Page 13
