Scribd
Upload
19 views1 page

Exercise 1

The document outlines a project to design a Smart Home Automation System using Arduino, LEDs, push buttons, and a DHT11 sensor for remote control of lights and fans. It includes steps for using Tinkercad to simulate the circuit and control devices based on button presses or temperature readings. A detailed project report must be prepared and submitted in a specified format, including a naming convention for the folder.

Uploaded by

11jaswanth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
19 views1 page

Exercise 1

The document outlines a project to design a Smart Home Automation System using Arduino, LEDs, push buttons, and a DHT11 sensor for remote control of lights and fans. It includes steps for using Tinkercad to simulate the circuit and control devices based on button presses or temperature readings. A detailed project report must be prepared and submitted in a specified format, including a naming convention for the folder.

Uploaded by

11jaswanth
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EXERCISE-1

Design Smart Home Automation System


Objective: Create a system to control LED lights and fans remotely.
Components: Arduino, LEDs, push buttons, and a DHT11 sensor.
Features: Control devices using virtual switches in Tinkercad and monitor room
temperature.
Methodology
1. Use virtual components such as LEDs, push buttons, and a DHT11 sensor
from Tinkercad's component library.
2. Write an Arduino sketch to control the LEDs based on button presses or
temperature/humidity readings.
3. Simulate the circuit to observe real-time control of LEDs.

Note- After completing the project, kindly prepare a detailed project report and
upload it to the LMS. Ensure the report is well-structured, includes all relevant
details, and adheres to the required format.
Once completed, compile them into a single PDF. The file should be named as
follows:
For example, if your name is Sivabalan P and your registration number is
23011103051 IoTB, then the folder name should be:
23011103051_Sivabalan_IoTB_Assignment1
Ensure your submission is clear, properly formatted, and adheres to the naming
convention.

You might also like