Wireless Pro Controller User Instruction
Model No.: 8575 Black
Update Instruction:
This wireless Pro controller is compatible with the latest version of Switch console when it’s out from
factory, in case Switch console will be upgraded again in future and the controller is unable to be connected
to Switch console, or the controller itself need to be updated for better functions, then this controller can be
updated by update software via connecting it to a PC. You can get the latest version update software from
your controller supplier and follow the instruction below to update the controller.
Please help us check the fragile sticker on your controller, if it's written with JRH-A/ B/C, it means you need
to update your controller. If it says JRH-D/E/F... Z, or doesn't have a sticker, it means you do not need to
update it. Be aware that do not update if your controllers don't need an update, because it might cause
some other issues if you do so.
If you need to update, please download the update file on a computer (Windows system, not Mac) from this
link: http://download.nsioutlet.com/E01240B.rar
If you don’t, please move to the part “Pairing Instruction” directly on the next page.
1. Unpack the file you just downloaded, run exe file. (named
"8575_ZXD1173_JRH_Switch_C087_0x0818_ver_24"). The “Update Firmware” button is inactive.
2. Connect the included USB cable to your controller.
3. While holding the left stick button, connect the controller to your computer using the USB cable. If you
have done this correctly, your controller will be recognized by the computer, and the "Update Firmware"
button is active now. If the update button is not showing, you have not connected it to your computer while
holding the LS Button.
Page 1 / 3
4. Click the "Update Firmware" button, wait a few seconds.
5. It’s done in no time.
Pairing Instruction:
(You only need to do pairing for the first time or after a firmware update.)
6. Turn on the Switch Console, select "Controllers" -- "Change Grip/order".
7. Hold on “HOME + Y” Buttons for 5s to search and sync, the LED starts blinking quickly, wait for about 10
seconds, it can be connected successfully, and the LED stops blinking. When the pairing is done, press on
the button "A" to operate.
Page 2 / 3
8. After first pairing, you only need press the “HOME” button for 5s to power on the controller, it will be
connected to the console automatically.
9. If the controller is in sleeping mode, press the “HOME” button to wake it up, it will be connected to the
console again automatically.
Note: If the controller connection failed, it may be caused by your switch have recorded too many
controllers before. In this situation, you should go to "System Setting--Controllers and Sensors--
Disconnect Controllers" to purge data, and then re-connect by following the steps above.
How to correct axis when you needed:
After the LEDs off, and the controller is disconnected. Place the controller on the flat surface on a table,
long press on the three keys simultaneously at the sequence start from “-“ key and “B” key and then
“HOME” key, the LEDs start blinking, release the three keys, next press on “+” key once on the controller,
the LEDs turn to be blinking circularly for a while then off, it means the axis is corrected successfully.
Page 3 / 3
