JCB LOADALL AGRI | 527-58
MAX. PAYLOAD: 2700kg (5952lb) MAX. LIFT HEIGHT: 5.8 m 19ft)
527-58
D J E K
F
B
G
STATIC DIMENSIONS
Low cab 20" tyres Standard cab 24" tyres Low cab 20" tyres Standard cab 24" tyres
A Overall height* m (ft-in) 2.00 (6-7) 2.15 (7-10) K Rear wheel centre to rear face m (ft-in) 0.61 (2-0) 0.61 (2-0)
B Overall width (over tyres)* m (ft-in) 2.04 (6.8 2.10 (6-10) Carriage roll back angle degrees 40 40
C Inside width of cab m (ft-in) 0.88 (2-10) 0.88 (2-10) Carriage dump angle degrees 40 40
D Front track m (ft-in) 1.60 (5-3) 1.70 (5-7) Outside turn radius (over tyres) 4WS m (ft-in) 3.15 (10-4) 3.46 (11-4)
E Wheelbase m (ft-in) 2.61 (8-7) 2.61 (8-7) Weight kg (lb) 5900 (13007) 5900 (13007)
F Overall length to front tyres m (ft-in) 3.73 (12-2) 3.83 (12-6) Tyres 308/75xR20 405/70xR24
G Overall length to front carriage m (ft-in) 4.42 (14-6) 4.42 (14-6) *Dependant upon tyre specified.
H Ground clearance m (ft-in) 0.3 (1-0) 0.36 (1-2) Note: Machine shown with standard cab, 24" tyres, and optional roof mounted air conditioning.
J Front wheel centre to carriage m (ft-in) 1.20 (3-11) 1.20 (3-11)
JCB LOADALL AGRI | 527-58
LIFT PERFORMANCE LIFT PERFORMANCE
Low cab 20" tyres Standard cab 24" tyres
Maximum lift capacity kg (lb) 2700 (5952) 2700 (5952)
Lift capacity to full height kg (lb) 2000 (4408) 2000 (4408)
Lift capacity at full reach kg (lb) 1250 (2755) 1250 (2755)
Lift height m (ft-in) 5.80 (19-0) 5.80 (19-0)
20
6 Reach at maximum lift height m (ft-in) 0.33 (1-1) 0.29 (0-11)
67° 1.9 m
Maximum forward reach m (ft-in) 3.00 (9-11) 2.90 (9-8)
18 60° 1.5 m
Reach with 1 tonne load m (ft-in) 3.00 (9-11) 2.90 (9-8)
5 1m Placing height m (ft-in) 4.54 (14-11) 4.54 (14-11)
16
50° Complies with stability test EN 1459 Annex B.
0.5 m
14 2,700kg
0m
4 40°
12
ENGINE
2,000kg
10 30° Latest technology and advanced design provides low fuel consumption, reduced noise, high torque and power output,
3
total reliability and minimal maintenance. Two-stage, dry type air filter with primary and safety elements.
8 1,500kg
Stage III
20°
2 Model Agri
6
1,250kg Manufacturer JCB
0.5m
10°
527-58
Displacement ltr (in³) 4.4 (269)
4
1 No. of cylinders 4
Bore size mm (in) 103 (4.05)
2
0° Stroke mm (in) 132 (5)
Aspiration Turbocharged
0 0
cooled
-6°
Power rating
2
Power @ 2200rpm kW (HP) 74.2 (100)
1 Torque rating
4 3 2 1 0 Metres
Torque @ 1300rpm Nm (lbf ft) 440 (324)
12 10 8 6 4 2 0 Feet
JCB LOADALL AGRI | 527-58
TRANSMISSION ELECTRICS
Closed loop variable displacement pump with a continuously variable hydrostatic drive. Comprising of a mechanical gearbox, 12v negative earth. 95 AH heavy duty battery. 95 amp alternator. Full road lighting. Reversing light.
hydraulic motor and control unit. Permanent 4 wheel drive. Travel speed: 20kph (12mph), 30kph (19mph) and 40 kph (25mph). Direction indicators. Hazard warning. Reverse alarm.
BRAKES
Service brakes – Hydraulically operated self-adjusting, oil-immersed in-board multi-disc type mounted on front axle. CAB
Parking brake – Hand operated disc brake on input of axle.
Quiet, safe and comfortable cab conforms to ROPS ISO 3471 and FOPS ISO 3449. Tinted glass all round, with laminated roof screen.
Roof bars, front screen and roof screen wipers and heater/screen demister. Rear opening window with wash/wipe. Audio-visual
BOOM AND CARRIAGE warning system for coolant temperature, engine oil pressure, air-cleaner, battery charge, transmission oil temperature and pressure,
water in fuel, hourmeter, road speed indicator, fuel gauge, engine temperature, clock and inclinometer. Adjustable suspension seat, tilt
Boom is manufactured from high tensile steel. Low maintenance, hard wearing pads. steer column, park brake, floor mounted throttle and brake pedals.
Tool carrier style parallel lift carriage with manual pin locking. Hydraulic controls:
Single lever servo joystick, incorporating forward/neutral/reverse, with progressive extend/retract and auxilliary incorporating
constant flow facility.
SAFETY CHECK VALVES Load Moment Indicator:
Automatic eye level audio-visual load moment indicator warning system receiving a signal from a load sensor on the rear axle.
Fitted to carriage tilt, telescopic and boom lift rams. This system continuously monitors the machine’s forward stability and leaves the operator in control at all times.
SERVICE CAPACITIES
Fuel tank litres (UK gal) 73 (16.1)
Hydraulic tank litres (UK gal) 66 (14.5)
STEERING
Coolant litres (UK gal) 22 (4.4)
Hydrostatic power steering with power track rods on both axles.
Three steer mode options: front wheel steer; all wheel steer; crab steer; operated from in the cab by a selection lever.
HYDRAULICS Option: In cab selector switch with Auto Align.
Two stage gear pump, fitted with suction strainer and filter. One boom end auxiliary hydraulic service fitted as standard.
Operating system pressure bar (psi) 260 (3770)
Flow at system pressure @ 2200rpm ltr/min (gal/min) 126 (27.7) OPTIONS AND ACCESSORIES
Hydraulic Cycle Times Seconds
Boom raise 4.7 Options: Low cab, 20" tyres, variable speed control with hand throttle, front and rear working lights, rotating flashing beacon, fire
Boom lower 3.4 extinguisher, front and roof screen guard, air conditioning, radial tyres, 2 boom end auxiliary services, sunblind, radio kit, carriage
hydraulic locking, limited slip differential in front axle, air suspension seat, reversing fan, 2-speed and intermittent front wash/wipers,
Extend 4.9
Smoothride, towing facility with trailer lighting package, carriage options available – contact your local dealer.
Retract 2.8
Attachments: Contact your local dealer for details of the comprehensive range.
Bucket dump 2.2
Adaptive Load Control for EU territories conforms to EN15000.
Bucket crowd 2.8
JCB LOADALL AGRI | 527-58
A GLOBAL COMMITMENT TO QUALITY
JCB’s total commitment to its products and customers has helped it grow from a one-man
business into Britain’s largest privately owned manufacturer of backhoe loaders, crawler excavators,
wheeled excavators, telescopic handlers, wheeled loaders, dump trucks, rough terrain fork lifts,
industrial fork lifts, mini/midi excavators, skid steer loaders, tractors and compaction equipment.
By making constant and massive investments in the latest production technology, the JCB factories
have become some of the most advanced in the world.
By leading the field in innovative research and design, extensive testing and stringent quality control,
JCB machines have become renowned all over the world for performance, value and reliability.
And with a global sales and service network of more than 650 dealers and agents, we aim to deliver
the best customer support in the industry.
Through setting the standards by which others are judged, JCB has become one of the world’s
most impressive success stories.
JCB Sales Limited, Rocester, Staffordshire ST14 5JP. Tel: 01889 590312. Fax: 01889 590588. Web: http://www.jcb.com
JCB reserves the right to change specifications without notice. Illustrations shown may include optional equipment and accessories. The JCB logo is a registered trademark of J C Bamford Excavators Ltd. 9999/5505 10/10 Issue 1
