Scribd
Upload
17 views1 page

Tail Lamp

The document outlines the procedure for removing and installing the taillamp on model 211.0, including necessary steps such as removing trim, expansion clips, and the hinge lever passage frame. It also specifies modifications made to the process and details for disconnecting electrical connectors and removing the taillamp itself.

Uploaded by

sonia eghwani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views1 page

Tail Lamp

The document outlines the procedure for removing and installing the taillamp on model 211.0, including necessary steps such as removing trim, expansion clips, and the hinge lever passage frame. It also specifies modifications made to the process and details for disconnecting electrical connectors and removing the taillamp itself.

Uploaded by

sonia eghwani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

AR82.10-P-4905T Remove/install taillamp 19.4.

06
MODEL 211.0

Shown on left-side luggage compartment lining

4 Expansion clip
5 Hinge lever passage frame

P82.10-4456-01

P82.10-2969-07

1 Bracket (with code (433) Left dynamic 2 Electrical connector M40/1 Pneumatic pump for dynamic seat
seat, incl. multi-contour seat or with 3 Nuts control (with code (433) Left
code (434) Right dynamic seat, incl. dynamic seat, incl. multicontour
multi-contour seat) E3 Left taillamp seat or with code (434) Right
E4 Right taillamp dynamic seat, incl. multicontour
seat)

Modification notes
8.3.06 Complete removal of side luggage compartment linings has Operation steps 1 to 4
been superseded with partial removal

Remove/install
1 Remove trim from rear end center assembly AR68.30-P-4785T
2 Remove expansion clips (4)
3 Remove hinge lever passage frame (5)
4 Release left or right side luggage
compartment lining until left taillamp (E3) or
right taillamp (E4) is accessible
5.1 Remove bracket (1) with pneumatic pump for Only when removing left taillamp (E3) on
dynamic seat control (M40/1) from retainer vehicles with code (433) Left dynamic seat,
and place to one side incl. multicontour seat or with code (434) Right
dynamic seat, incl. multicontour seat.
6 Disconnect electrical connector (2)
7 Remove nuts (3) and remove left taillamp (E3)
or right taillamp (E4)
8 Install in the reverse order

You might also like