Safety Data Sheet
Revision Number: 003.6 Issue date: 04/04/2022
1. PRODUCT AND COMPANY IDENTIFICATION
Product name: BONDERITE L-MR B-200 MACHINING IDH number: 838406
LUBRICANT known as MULTAN B-200
Product type/use: Lubricant
Restriction of Use: None identified Region: United States
Company address: Contact information:
Henkel Corporation Telephone: +1 (860) 571-5100
One Henkel Way MEDICAL EMERGENCY Phone: Poison Control Center
Rocky Hill, Connecticut 06067 1-877-671-4608 (toll free) or 1-303-592-1711
TRANSPORT EMERGENCY Phone: CHEMTREC
1-800-424-9300 (toll free) or 1-703-527-3887
Internet: www.henkelna.com
2. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
DANGER: CAUSES SKIN IRRITATION.
MAY CAUSE AN ALLERGIC SKIN REACTION.
CAUSES SERIOUS EYE DAMAGE.
SUSPECTED OF DAMAGING FERTILITY OR THE UNBORN CHILD.
HAZARD CLASS HAZARD CATEGORY
SKIN IRRITATION 2
SERIOUS EYE DAMAGE 1
SKIN SENSITIZATION 1
REPRODUCTIVE TOXICITY 2
PICTOGRAM(S)
Precautionary Statements
Prevention: Obtain special instructions before use. Do not handle until all safety precautions have been
read and understood. Avoid breathing vapors, mist, or spray. Wash affected area thoroughly
after handling. Contaminated work clothing should not be allowed out of the workplace. Wear
protective gloves, clothing, eye and face protection.
Response: IF ON SKIN: Wash with plenty of water. IF IN EYES: Rinse cautiously with water for several
minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF exposed or
concerned: Get medical attention. If skin irritation or rash occurs: Get medical attention. Take
off contaminated clothing.
Storage: Store locked up.
Disposal: Dispose of contents and/or container according to Federal, State/Provincial and local
governmental regulations.
4 % of the mixture consists of ingredient(s) of unknown acute toxicity.
Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the
United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS).
See Section 11 for additional toxicological information.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Component(s) CAS Number Percentage*
IDH number: 838406 Product name: BONDERITE L-MR B-200 MACHINING LUBRICANT known as MULTAN B-200
Page 1 of 5
Distillates (petroleum), hydrotreated
64742-52-5 10 - 30
heavy naphthenic
Dicyclohexylamine 101-83-7 1-5
Oleylamidoethyleneoxyethanol Proprietary 5 - 10
Boric acid (H3BO3), compd. with 2-(2-
124756-59-8 1-5
aminoethoxy)
Amine borate Proprietary 1-5
Diglycol amine 929-06-6 1-5
Monoethanolamine 141-43-5 0.1 - 1
* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.
4. FIRST AID MEASURES
Inhalation: If inhaled, immediately remove the affected person to fresh air. If symptoms
develop and persist, get medical attention.
Skin contact: Immediately wash skin thoroughly with soap and water. If symptoms develop
and persist, get medical attention.
Eye contact: In case of contact with the eyes, rinse immediately with plenty of water for 15
minutes, and seek immediate medical attention.
Ingestion: Get medical attention. DO NOT induce vomiting unless directed to do so by
medical personnel. Never give anything by mouth to a victim who is
unconscious or is having convulsions.
Symptoms: See Section 11.
Notes to physician: This material, if aspirated into the lungs, may cause chemical pneumonitis;
treat the affected person appropriately.
5. FIRE FIGHTING MEASURES
Extinguishing media: Water spray (fog), foam, dry chemical or carbon dioxide.
Special firefighting procedures: Wear full protective clothing. Wear self-contained breathing apparatus.
Unusual fire or explosion hazards: This product is an aqueous mixture and although it will exhibit a flash point, it
will not support combustion.
Hazardous combustion products: Upon decomposition, this product emits oxides of sulfur, carbon monoxide,
carbon dioxide and/or low molecular weight hydrocarbons. Oxides of nitrogen.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and
unprotected personnel.
Environmental precautions: Prevent further leakage or spillage if safe to do so. Wear appropriate
protective equipment and clothing during clean-up. Do not allow product to
enter sewer or waterways.
Clean-up methods: Absorb spill with inert material. Shovel material into appropriate container for
disposal. Dispose of according to Federal, State and local governmental
regulations.
7. HANDLING AND STORAGE
Handling: Avoid contact with eyes, skin and clothing. Wash thoroughly after handling.
Avoid breathing vapors or mists of this product. For industrial use only. Do not
mix this product with fluids which contain NITRITES/NITRATES.
NITROSAMINE may be formed.
Storage: Not available.
For information on product shelf life, please review labels on container or check the Technical Data Sheet.
IDH number: 838406 Product name: BONDERITE L-MR B-200 MACHINING LUBRICANT known as MULTAN B-200
Page 2 of 5
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper
exposure controls and protective equipment for each task performed.
Hazardous Component(s) ACGIH TLV OSHA PEL AIHA WEEL OTHER
5 mg/m3 PEL Mist.
Distillates (petroleum), hydrotreated 5 mg/m3 TWA
500 ppm (2,000 None None
heavy naphthenic Inhalable fraction.
mg/m3) PEL
Dicyclohexylamine None None None None
Oleylamidoethyleneoxyethanol None None None None
Boric acid (H3BO3), compd. with 2-(2-
None None None None
aminoethoxy)
Amine borate None None None None
Diglycol amine None None None None
6 ppm STEL 3 ppm (6 mg/m3)
Monoethanolamine None None
3 ppm TWA PEL
Engineering controls: Provide local and general exhaust ventilation to effectively remove and
prevent buildup of any vapors or mists generated from the handling of this
product.
Respiratory protection: If mist is generated (heating, spraying) and engineering controls are not
sufficient, wear approved organic vapor respirator suitable for oil mist.
Eye/face protection: Wear safety glasses; chemical goggles (if splashing is possible).
Skin protection: Chemical resistant, impermeable gloves. Gloves should be tested to
determine suitability for prolonged contact. Use of impervious apron and boots
are recommended.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Liquid
Color: Amber
Odor: Amine
Odor threshold: Not available.
pH: 9.5 - 10.5
Vapor pressure: Not determined
Boiling point/range: > 98.8 °C (> 209.8 °F)calculated
Melting point/ range: Not applicable
Specific gravity: 1.00 - 1.01
Vapor density: Not determined
Flash point: Not determined
Flammable/Explosive limits - lower: Not applicable
Flammable/Explosive limits - upper: Not applicable
Autoignition temperature: Not applicable
Flammability: Not applicable
Evaporation rate: Not applicable
Solubility in water: Complete
Partition coefficient (n-octanol/water): Not determined
VOC content: Not determined
Viscosity: 100 mPa.s
Decomposition temperature: Not available.
10. STABILITY AND REACTIVITY
Stability: Stable at normal conditions.
Hazardous reactions: Will not occur.
Hazardous decomposition Upon decomposition, this product emits carbon monoxide, carbon dioxide and/or low
products: molecular weight hydrocarbons. Oxides of nitrogen. Oxides of sulfur.
Incompatible materials: This product may react with strong acids or oxidizing agents. Nitrites may react with organic
amines to form nitrosamines which can cause cancer.
Reactivity: Not available.
Conditions to avoid: Keep away from heat, ignition sources and incompatible materials.
IDH number: 838406 Product name: BONDERITE L-MR B-200 MACHINING LUBRICANT known as MULTAN B-200
Page 3 of 5
11. TOXICOLOGICAL INFORMATION
Relevant routes of exposure: Skin, Inhalation, Eyes, Ingestion
Potential Health Effects/Symptoms
Inhalation: This product is irritating to the respiratory system.
Skin contact: This product is irritating to the skin. May cause sensitization by skin contact.
Eye contact: Causes serious eye damage.
Ingestion: Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Hazardous Component(s) LD50s and LC50s Immediate and Delayed Health Effects
Inhalation LC50 (Rat, 4 h) = > 4.026 mg/l
Inhalation LC50 (Rat, 4 h) = 2.18 mg/l
Distillates (petroleum), hydrotreated
Inhalation LC50 (Rat, 4 h) = 10.5 mg/l Irritant
heavy naphthenic
Inhalation LC50 (Rat, 4 h) = > 5.2 mg/l
Inhalation LC50 (Rat, 4 h) = < 5.7 mg/l
Allergen, Blood, Central nervous system,
Dicyclohexylamine Oral LD50 (Rat) = 373 mg/kg
Corrosive, Irritant, Kidney, Liver, Mutagen
Oleylamidoethyleneoxyethanol None No Records
Cardiac, Central nervous system,
Boric acid (H3BO3), compd. with 2-(2-
None Developmental, Gastrointestinal, Irritant,
aminoethoxy)
Kidney, Metabolic, Reproductive
Cardiac, Central nervous system,
Amine borate None Developmental, Gastrointestinal, Irritant,
Kidney, Metabolic, Reproductive
Diglycol amine None Corrosive, Irritant
Oral LD50 (Rat) = 10.2 g/kg
Irritant, Kidney, Liver, Corrosive, Respiratory,
Monoethanolamine Oral LD50 (Mouse) = 700 mg/kg
Developmental
Dermal LD50 (Rabbit) = 1,025 mg/kg
OSHA Carcinogen
Hazardous Component(s) NTP Carcinogen IARC Carcinogen
(Specifically Regulated)
Distillates (petroleum), hydrotreated
No No No
heavy naphthenic
Dicyclohexylamine No No No
Oleylamidoethyleneoxyethanol No No No
Boric acid (H3BO3), compd. with 2-(2-
No No No
aminoethoxy)
Amine borate No No No
Diglycol amine No No No
Monoethanolamine No No No
12. ECOLOGICAL INFORMATION
Ecological information: Harmful to aquatic organisms.
13. DISPOSAL CONSIDERATIONS
Information provided is for unused product only.
Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal.
14. TRANSPORT INFORMATION
The transport information provided in this section only applies to the material/formulation itself, and is not specific to any
package/configuration.
U.S. Department of Transportation Ground (49 CFR)
Proper shipping name: Not regulated
Hazard class or division: None
Identification number: None
Packing group: None
IDH number: 838406 Product name: BONDERITE L-MR B-200 MACHINING LUBRICANT known as MULTAN B-200
Page 4 of 5
International Air Transportation (ICAO/IATA)
Proper shipping name: Not regulated
Hazard class or division: None
Identification number: None
Packing group: None
Water Transportation (IMO/IMDG)
Proper shipping name: Not regulated
Hazard class or division: None
Identification number: None
Packing group: None
15. REGULATORY INFORMATION
United States Regulatory Information
TSCA 8 (b) Inventory Status: All components are listed as active or are exempt from listing on the Toxic Substances
Control Act (TSCA) inventory.
TSCA 12 (b) Export Notification: Amine borates (CAS# 124756-59-8).
CERCLA/SARA Section 302 EHS: None above reporting de minimis.
CERCLA/SARA Section 311/312: Immediate Health, Delayed Health
CERCLA/SARA Section 313: None above reporting de minimis.
California Proposition 65: This product contains a chemical known to the State of California to cause birth defects or
other reproductive harm. This product contains a chemical known in the State of California
to cause cancer.
Canada Regulatory Information
CEPA DSL/NDSL Status: One or more components are not listed on, and are not exempt from listing on either the
Domestic Substances List or the Non-Domestic Substances List.
16. OTHER INFORMATION
This safety data sheet contains changes from the previous version in sections: New Safety Data Sheet format.
Prepared by: Regulatory Affairs
Issue date: 04/04/2022
DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel
Corporation and its affiliates (“Henkel”) does not assume responsibility for any results obtained by persons over whose methods
Henkel has no control. It is the user’s responsibility to determine the suitability of Henkel’s products or any production methods
mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and
persons against any hazards that may be involved in the handling and use of any Henkel’s products. In light of the foregoing,
Henkel specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular
purpose, arising from sale or use of Henkel’s products. Henkel further disclaims any liability for consequential or incidental damages
of any kind, including lost profits.
This Safety Data Sheet has been generated based on OSHA Hazard Communication Standard (29 CFR 1910.1200) and provides
information in accordance with U.S. federal law only. No warranty or representation of any kind is given with respect to the
substantive or export laws of any other jurisdiction or country. Please confirm that the information provided herein conforms to the
substantive export or other law of any other jurisdiction prior to export. Please contact Henkel Product Safety and Regulatory
Affairs for additional assistance.
IDH number: 838406 Product name: BONDERITE L-MR B-200 MACHINING LUBRICANT known as MULTAN B-200
Page 5 of 5
