Scribd
Upload
18 views1 page

Bs 680682684

The document provides technical specifications for manually resettable electro valves, including models BS-680, BS-682, and BS-684, detailing their voltage, consumption, pressure, and operational temperature range. It outlines installation instructions, manual reset procedures, and servicing guidelines, emphasizing that these operations should be performed by skilled personnel. The solenoid valves comply with directive 94/9/CE for safety and functionality.

Uploaded by

MT RT
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
18 views1 page

Bs 680682684

The document provides technical specifications for manually resettable electro valves, including models BS-680, BS-682, and BS-684, detailing their voltage, consumption, pressure, and operational temperature range. It outlines installation instructions, manual reset procedures, and servicing guidelines, emphasizing that these operations should be performed by skilled personnel. The solenoid valves comply with directive 94/9/CE for safety and functionality.

Uploaded by

MT RT
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Manually resettable electro valves

TECHNICAL SPECIFICATIONS BS-680 BS-682 BS-684


Mains voltage 24V DC 230V AC/50-60Hz 12V DC
Consumption 4VA 6VA
Pressure (max) 6 bar
Valve type N.O. 1/2"
Degrees of protection IP 65
Temperature operation range -15 to 60 ο C
Guarantee 2 years

GENERAL
The solenoid valve is in conformity with the directive 94/9/ CE as device of group II, category 3G and as
device of group ΙΙ category 3D.
Installation
The solenoid valve is normally installed after the gas supply and before the consumptios. It must be installed
with the arrow (shown on the body valve) towards the user.
Manual reset
To reset the solenoid valve, act as follows:
be sure, that the solenoid valve is not electrically powered and push to the end the reset hand grip (1) up
to the hooking.
Servicing
Before doing any disassembling operation be sure that there is no gas in pressure
inside the solenoid valve and it is not electrically powered, then act as follows:
unscrew the lower cap (10) from the body valve (13) and check the obturator (7) .
If it is necessary substitute the seal washer (11)
Warning
The above - said operations must be carried on only by skilled people.

1 2 3 4

5
14
1 - Reset handgrip
2 - Aluminum washer
3 - Coil armature assebly 13
4 - Electrical coil
5 - Electrical connector
6 - Plunger 12 6
7 - Obturator
8 - Seal Ο-ring
9 - Closing spring
10 - Lower cap 7
11 - Seal washer
12 - Filtering organ (on request) 11
13 - Body valve
14 - Central pin
10 9 8

980168400_23_004

You might also like