Scribd
Upload
8 views1 page

Procedure

The procedure outlines the steps for setting up a circuit involving a power analyser, resistor, inductor, and capacitor. It includes connecting components and measuring total current and voltage using a multimeter. Finally, the recorded values are documented in a table.

Uploaded by

kiboame27
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
8 views1 page

Procedure

The procedure outlines the steps for setting up a circuit involving a power analyser, resistor, inductor, and capacitor. It includes connecting components and measuring total current and voltage using a multimeter. Finally, the recorded values are documented in a table.

Uploaded by

kiboame27
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PROCEDURE

 Firstly I switched on the Mains and the supply link


 Then rotated the emergency stop and the switch on then pressed the on button
 I had wires then I connected a wire from the Live power outputs to the Power
analyser then from the analyser to the resistor
 From the resistor to the inductor and from the inductor to the capacitor
 Then from the capacitor to the Neutral power output
 From there I changed the capacitor(1-3) the resistor(1-5) and the inductor(1-5)to
measure the total current and voltage through each of them
 From then I used the power analyser to measure the total current in the circuit
 Then I place two wires into the Multimeter one into the Com and one to the voltage
measure to measure the voltage through each of them
 Then I recorded the values in the table

You might also like