Type: SPD44
Surge Protection Device
Terminal
Protection Protects equipment against over voltage transients
to IP20 Incorporates both Metal Oxide Varistors and Gas Discharge Tubes
Long working life
Fast response time
Neon indicator for supply presence
Grouped terminals for ease of connections
Suited to single-phase applications
DIN Rail mounting
Dims: to DIN
43880
W. 44mm
• FRONT INDICATION • TECHNICAL SPECIFICATION
Supply voltage Un: (L, N) 230/240V AC/DC
1. Supply present (Orange) neon Frequency range: 48 – 63Hz (AC supplies)
Overvoltage category: III (IEC 60664)
Rated impulse withstand voltage: 4kV (1.2/50µS) IEC 60664
Supply present indication: Orange Neon
Current rating: 16A (when used with a suitable Miniature Circuit
Breaker)
Leakage current: 100µA @ 250V AC
Response time: < 25ns
Capacitance: < 5nF @ 1kHz
Insulation resistance: > 1000 MΩ (applicable to internal Metal Oxide Varistors
➊ only)
Voltage temperature co-efficient: -0.05%/°C (applicable to internal Metal Oxide Varistors
only)
Max. clamping voltage: < 900V (Phase/neutral)
(with current waveform 1.2/50µs < 1300V (Phase/earth)
– Short circuit current 100A ±10A)
Transient withstand capacity: x5 @ 5kA (Phase/neutral)
x3 @ 5kA (Phase/earth)
(8/20µs waveform)
• INSTALLATION Installation work must be carried Ambient temp: -20 to +60°C
out by qualified personnel. Relative humidity: +95% max.
• BEFORE INSTALLATION, ISOLATE THE SUPPLY.
Housing: Grey flame retardant Lexan UL94 V0
• The diagram below shows a typical example whereby the unit is protecting a single phase installation.
Weight: 48g
• Depending on circuit ratings, the fuse size should be chosen accordingly. Mounting option: On to 35mm symmetric DIN rail to BS EN 60715
Terminal conductor size ≤ 2 x 2.5mm2 solid or stranded
Terminal layout/Connections. Approvals: Conforms to IEC.
• Despite only requiring 3 actual connections, additional terminals are provided allowing several wires to
be terminated if required. CE, and RoHS Compliant.
EMC:
Immunity: EN 61000-6-2
Applying power.
Emissions: EN 61000-6-4
• As soon as power is applied, the orange colour “SUPPLY” ➊ neon will illuminate.
Troubleshooting.
• If the orange neon fails to illuminate, check the voltage is present to terminals L and N and within the
working limits of the device
• Also check the external protection fuse has not blown.
• CONNECTION DIAGRAM
• DIMENSIONS
30mm
44mm 49.5mm
63.5mm
85mm
61mm
45mm
Broyce Control Ltd., Pool Street, Wolverhampton, West Midlands WV2 4HN. England SPD44-1-A.DOCX
Tel: +44 (0) 1902 773746 Fax: +44 (0) 1902 420639 Email: sales@broycecontrol.com Web: www.broycecontrol.com 2009
The Information provided in this literature is believed to be accurate (subject to change without prior notice); however, use of such information shall be entirely at the user’s own risk.
