Pro 1000 Plus
Pro 1000 Plus
TECHNICAL LETTER
For the sample "COLOR LIFE," each base is used in IN RELATION TO THE ENVIRONMENT
the following colors: This product is made with raw materials that are not
Vivid B1 in most regulars and grays with ending made from lead or mercury.
01 and 02.
Vivid B2some of regulars and grays with ending 03, 4. APPLICATION DATA
04 and 05.
Vivid B3 in most regulars and grays with a finish SURFACE PREPARATION
06, 07 and 08. The surface must be free of any contaminants that
Vivid B4some of regulars and grays with ending 09,10 hinders the adhesion of the paint like dust, grease, including
y 11. saltpeter and alkalinity.
For the sample "COLOR LIFE 2", each base is used in INSTRUCTIONS ON MIXING
the following colors: Mix well before use and occasionally during the
Vivid B1 most colors with ending 01 and 02 application.
except offwhites and colors with chromaticity 'A'. When using more than one container of the same color, mix them between each other.
Vivid B2 most colors ending in 03 except if before using them to uniform the color.
off-whites and colors with chromaticity 'A'.
Vivid B3 the majority of colors with ending 04 except DILUTION
colors with chromaticity "A". The product can be diluted with water when applied with
Vivid B4 Most colors ending in 05 except pistol or spraying equipment. When applied with a brush the
colors with chromaticity "A". paint should be diluted no more than 15% with water.
When the application is with a roller, the paint must be diluted.
a maximum of 10% with water.
TECHNICAL LETTER
Team Airless. For large areas, follow the CLEANING OF THE EQUIPMENT
recommendations for the type of nozzle and filter from the manufacturer of Wash the brush, the rollers, and other painting tools with water.
team. and soap immediately after using them.
When painting for prolonged periods, the paint
Brush. Recommended for very rough surfaces accumulates at the base of the bristles of the brush. Wash with water and
after with standard Thinner Comexo with another solvent of
PRECAUTIONS WHEN APPLYING good quality. The application equipment should be cleaned last.
Apply only if the air temperature, the surface to with Comex turpentine or with another solvent to help prevent
painting and the product are between 10° C (50° F) and corrosion.
the 33°C(90°F). Avoid applying the paint when the humidity
relative is above 80% as it does not allow to dry. If 5. PRODUCT MANAGEMENT
it is going to paint the exterior it should be avoided to paint late when there is
more likelihood of dew and condensation, do not apply the
painting if there is a suspicion of rain. Avoid it freezing. INFLAMMABILITY
Water-based material, non-flammable.
APPLICATION
After preparing the surface, apply the sealer. STORAGE
suitable before painting. In original sealed packaging, stored indoors at a temperature
5x1 Classic for indoor surfaces or repainted without environment between 5 and 35° C. Preferably use before 24
alkalinity or saltpeter problems. months from the manufacturing date.
5x1 Reinforced For new outdoor surfaces or with It should be kept in cool and dry places, after its
alkalinity problems. Keep tightly closed and out of reach of children.
Inkable sealant (matched to a color similar to the paint of
finished). For healthy interior or exterior surfaces 6. PRODUCT LIMITATIONS
where the finish color to be applied by nature is present It is not recommended to use on floors, terraces, stairs, or in other
under covering power. areas where one must step.
Alkali Sealant: For surfaces with alkalinity or It is not a product that withstands corrosive chemicals.
light saltpetre. high temperatures, and no other extreme conditions. There is no
Refer to the technical datasheet of the required product for each it is recommended for use on concrete surfaces directly
case. in contact with loose dirt floors, nor use in
Then apply 2 layers of PRO-1000-PLUS to achieve the areas that are constantly wet or damp.
color development.
TECHNICAL LETTER