Scribd
Upload
4 views53 pages

Menu

The document provides instructions for entering various adjustment and utility modes for the JMA-9900 device. It details steps for accessing the adjustment mode, skipping the pre-heat timer, displaying version information, and entering several special menus. Additionally, it includes instructions for outputting debug codes and clearing backup data.

Uploaded by

SunilKhetan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4 views53 pages

Menu

The document provides instructions for entering various adjustment and utility modes for the JMA-9900 device. It details steps for accessing the adjustment mode, skipping the pre-heat timer, displaying version information, and entering several special menus. Additionally, it includes instructions for outputting debug codes and clearing backup data.

Uploaded by

SunilKhetan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 53

Special Setting

JMA-9900
2004/04/21

1. To Enter ADJUSTMENT MODE


Click “MENU” or press “Option2” key.
Click “CODE INPUT” on the menu. (CODE INPUT MENU is opened)
Click “0”and ”Enter” on the Code-Input-dialog.
Adjust menu is opened.

2. To skip pre-heat timer.


(When operate this function, please keep magnetron preheat time)
Press and hold “TX/STBY key, until preheat timer is disappear. (about 5 seconds)

3. To display Version Information.


Click “TEST”. (or press “Option1” key)
Click “System Information”.
Click numerical number part of System-No. (Then Appear code input dialog)
Clicks “9”,”8”,”0”,”0”,”ENTER”.
Then detail version information is displayed.

4. To enter “Utility Menu”


(Careful to change this menu value.)
Clicks “9”,”8”,”0”,”0”,”1”,”ENTER” on the CODE INPUT MENU.

5. To enter “Special Set Menu”


(Careful to change this menu value.)
Clicks “9”,”8”,”0”,”0”,”9”,”2”,”ENTER” on the CODE INPUT MENU.

6. To enter “Special ARPA Menu”.


(Careful to change this menu value.)
Clicks “9”,”8”,”0”,”0”,”9”,”3”,”ENTER” on the CODE INPUT MENU.

7. To enter “Special SP Menu”.


(Careful to change this menu value.)
Clicks “9”,”8”,”0”,”0”,”9”,”4”,”ENTER” on the CODE INPUT MENU.

8. To output debug code with serial port.


Clicks “9”,”8”,”0”,”0”,”9”,”8”,”ENTER” on the CODE INPUT MENU.
This function is turn off after power-off.

9. To Clear all back up data


Clicks “9”,”8”,”0”,”0”,”1”,”ENTER” on the CODE INPUT MENU. : (Utility menu is displayed.)
Click “9.AREA INITIAL”.
Click “YES” on the yes/no-dialog.

You might also like