Northrop Grumman B-2 Spirit Bend and glue to
shape (till the
middle "gap" is
tight)
0
0
1
1
2
2
3
3
4 5cm
1:400 scale - print at 100%
1:500 scale - print at 80%
4cm
Print with 100% scale
setting, not "fit to
Left engine
(paint inside face black)
Right engine
(paint inside face black)
Main bomb bay door
(when opened, optional)
paper" setting 1:400
8201
scale @ A4 paper
1028
1028
Light green
side glue to
0
wing When glue to fuselage,
the sides needs to
gently pushed in and
(< front) Left Right (front > ) up (as indicated by the
arrows).
Bend Bend (optional)
up up Cut landing gear door and/
Fold Fold Fold Fold or bomb bay door at belly
170o 170o 170o 170o for opened position (and
expose wing filler level 2)
When glue to fuselage, align
(1) (1)
this highlighted profile to wing
(between engine exhaust) first .
Bend slightly to
follow contour of
wing fillers
11
9
(optional)
Cut our landing gear
bay door for "gear
down" position and
expose wing filler
level 2
(optional) (optional)
Cut out this Cut out this
bit to make bit to make
the engine fit the engine fit
tighter to the tighter to the
wing wing
1 3
10
(largest)
(optional)
Fold Cut these black Fold
180o engine exhausts to 180o
form a slight recess
(and expose wing
2
filler level 12)
Steps:
3 5
7
1 - Double the thickness of wing fillers
(numbered 3 to 12) by glueing (at least)
another sheet of paper to their back, glue
them all together.
2 - Cut and fold the main wing (numbered 1
and 13) as per the detailed guidance.
3 - Glue the wing and wing fillers together.
(fa
ce
do
wn)
4
Start at the nose, and make sure it is
centred, ie. no wing fillers exposed. Also
check for a smooth bottom seam.
4 - Cut, fold, and then glue the engines onto
8 6
the wing. Make hard and sharp folds on the
engine sides to make the engine shape flow
better with the wing.
*Note: put extra weight inside nose to
5 - Cut, bend, and then glue the cockpit into ensure balance on wheels with no "tail
strike"
1:400
shape. Glue it onto the wing as per the
detailed guidance.
- This is NOT a model
licensed by
manufacturer/ airline
6- Landing gears, reinforce where needed
as usual. 12 little_model_airport
