Panduit Corp.
Terminal Division
T-MSDS-003-PC By: LEM Date: 06/14/07 Page: 1 of 3 Rev.: AA
Panduit Corp. 17301 S. Ridgeland Avenue Tinley Park, IL 60477-3091 (800) 535-5053 (US) (352) 323-3500 (International) Ref 29 CFR 1910.1200 (g)
MATERIAL SAFETY DATA SHEET for CMP-100-1 HMIS Rating HMIS/NFPA Hazard Identification system: 0-Minimal 1-Slight 3-High 4-Extreme *-Chronic Health: 1 Flammability: 0 D2B Reactivity: 0 2-Moderate
WHMIS Hazard Identification System: SECTION 1
IDENTITY Trade Name CMP-100 Chemical Family: Castor Oil Derivative CAS No. Not Listed Formula: Proprietary Compound SECTION 2 HAZARDOUS INGREDIENTS Zinc Dust CAS# 7440-66-6 30% SECTION 3 PHYSICAL & CHEMICAL CHARACTERISTICS Boiling Point: N/A Vapor Density: Heavier than air Solubility in water: Insoluble Appearance: Thick, gray abrasive grease Reactivity in water: N/A Vapor Pressure: N/A % Volatile by Volume: Nil Specific Gravity: 1.36 Odor: Mild Evaporation Rate: N/A TLV 10 Mg/Cubic Meter
Panduit Corp. Terminal Division
T-MSDS-003-PC By: LEM Date: 06/14/07 Page: 2 of 3 Rev.: AA FIRE & EXPLOSION DATA
SECTION 4
Flash Point: > 500 F COC. Auto Ignition Temperature: > 500 F Extinguishing Media: Foam, carbon dioxide, dry chemical Special Fire Fighting Procedures: Standard firemans body protection and selfcontained breathing apparatus is recommended Unusual Fire and Explosion Hazards: Keep container tightly closed and away from heat and open flames. Closed containers may explode. Fire may produce dense, black smoke.
SECTION 5 PHYSICAL HAZARDS (REACTIVITY DATA) Stability: Stable Incompatibility, materials to avoid: Contact with oxidizing material. Hazardous decomposition products: Products of incomplete combustion may include CO, CO2, and dense black smoke. Hazardous Polymerization: Will not occur.
SECTION 6 HEALTH HAZARDS Effects of over exposure: Acute: May cause skin and eye irritation Chronic: Skin or eye irritation. There are no other known chronic effects for this product. Emergency and first aid procedures: Eyes: Flush with water for at least 15 minutes; consult a physician. Skin: Wash thoroughly with soap and water. If irritation occurs, consult a physician. Ingestion: Consult a physician. SECTION 7 SPECIAL PRECAUTIONS AND SPILL/LEAK PROCEDURES Precautions to be taken in handling and storing: Store in closed container. Protect from contamination with other materials. Do not transfer into marked containers. Steps to be taken in case material is released or spilled: Scoop up material. Use sand, earth, sawdust, or other absorbent if necessary.
T-MSDS-003-PC By: LEM Date: 06/14/07 Page: 3 of 3 Rev.: AA Waste disposal: Dispose of in accordance with state, local, and federal regulations.
SECTION 8 SPECIAL PROTECTION INFORMATION/CONTROL MEASURES Respiratory protection: None required under normal conditions Ventilation: Use in open, well vented area. Protective Gloves: Chemical resistant gloves. Eye Protection: Goggles or safety glasses. Other Protection: As required to prevent dermal contact. Safety shower and eyewash should be provided OTHER COMMENTS The responsibility to provide a safe work place remains with the user. The user should consider the health hazards and safety information contained herein as a guide and should take those precautions required in an individual operation to instruct employees and to develop work practice procedures for a safe work environment. DISCLAIMER: The information contained herein is, to the best of our knowledge and belief, accurate. However, because the conditions of handling and use are beyond our control, we make no guarantee of results, and assume no liability for damages uncured by the use of this material. It is the responsibility of the user to comply with all federal, state, and local laws and regulations.
T-MSDS-003 REVISION SHEET
Rev No 00 AA
Revision Made Specification released. Updated MSDS to reflect Corp. address information.
Rev Date 06/14/07 01/16/08
Eng JTH LEM
ECN #
