AB 320 Flows F/O
Flow Flightdeck Equipment Trigger
This flow is accomplished on the first flight of the day, after a crew change, prior to an oceanic flight, or when the flightdeck has been left unattended and not in view of a pilot crewmember.
FDML, Forms & Manuals, and Flight Kits- Checked CA Life Vest - Checked CA EFB (as installed) - On Escape Rope - Checked Overhead Circuit Breakers (49VU) - Checked Escape Rope - Checked FO EFB (as installed) - On Landing Gear Control Handle - Down ECAM - Checked Flaps & Spoilers - Checked Aircell Handset (as installed) - On FO Life Vest - Checked PBE - Checked Fire Extinguisher - Checked Gear Pins - Stowed Crash Axe - Stowed Circuit Breakers - Checked Observers Life Vests - Checked Compartmentalized Areas - Checked Flightdeck Door - Checked
(www.airbusdriver.net)
April 20, 2013
Flightdeck Preparation
This flow is accomplished on the first flight of the day, after a crew change, prior to an oceanic flight, or when the flightdeck has been left unattended and not in view of a pilot crewmember.
MAINTENANCE Panel - Checked Third Occupant ACP - Checked Third Occupant RMP - Checked FLT CTL Panel - Checked CARGO HEAT Panel - Checked CARGO SMOKE Panel - Checked VENTILATION CTL Panel - Checked ENG Panel (Overhead) - Checked RAIN RPLNT/WIPER Panel - Checked Glareshield, Right Side - Checked EFIS Control Panel - Checked FCU - Checked Center Instrument Panel - Checked EIS Switching Panel - Checked Thrust Levers - Fwd Idle Pitch Trim Wheels - Checked ATC / TCAS Control Panel - Checked Flood Light - Checked ACP - Checked RMP - Checked MCDU - Set Instrument Panel - Checked EFB (as installed) - Checked Oxygen & Interphone - Checked Flight Kit Contents/Dates - Checked
Before Start
Approximately 15 minutes prior to departure and after ATC Route Clearance Verification is completed. Assumes clearance received and APU started.
EFIS Control Panel- Set FCU - Checked TERR ON ND - As required ECAM - Checked Transponder - Set ACP - Set RMP - Set MCDU - Set ND - Checked PFD - Checked Window - Closed/Locked Oxygen - Checked Departure Briefing - Brief if PF After the captain calls Before Start Checklist Accomplish Before Start Checklist
Before Pushback
After receiving the cabin ready notification and all doors are closed and armed.
N/W STRG DISC Memo - Checked Pushback/Start Clearance - Obtain
After Start
After ground equipment is clear, first officer verbally acknowledges the captains wands up signal statement, and engine(s) are stabilized.
ENG MODE Selector - NORM or IGN/START Y ELEC PUMP - ON or Off GEN 2 - On or OFF APU BLEED - ON or Off ENG ANTI ICE - ON or Off APU MASTER SW - ON or Off ECAM - Checked Flaps - Set After the captain calls Flaps ___, Taxi Flaps - Ensure Commanded Position
Taxi
After departing the gate, final weight and balance received, and both engines running.
Flight Controls - Checked AUTOBRK - MAX Takeoff Data/Flex - Checked Pitch Trim - Set Flaps - Set Rudder Trim - Reset WINDSHEAR/PWS (as installed) - AUTO T.O. CONFIG - Checked After the captain calls Taxi Checklist Accomplish Taxi Checklist (To the Line)
Before Taking the Runway
Approximately 1-3 minutes prior to taking the runway.
Flight Attendants - Notified RADAR - WX or OFF ENG MODE - NORM or IGN TCAS - TA/RA Runway & FMS - Check After the captain calls Below the Line Accomplish Taxi Checklist (Below the Line)
After Takeoff (PM)
After flap retraction and prior to 10,000 feet MSL.
AIR COND - Checked Landing Gear - Checked Flaps - Checked Cabin Vertical Speed - Checked Accomplish After Takeoff Checklist silently; verbalize After Takeoff Checklist Complete
Climbing through 10,000 feet MSL Through (PM - 10,000 ECAM - Checked) 10,000 Feet Climbing through the transition altitude. Transition BARO SET - PULL STD Altitude PFDs - Crosscheck
PM RMP/ACP - 121.5 Monitor PM calls Transition, Standard PF responds Standard
(PF) External Lights - As required (As installed) NO PORTABLE ELEC EVICE/NO SMOKING - OFF or SEAT BELTS - Cycle
Transition Level
Descending through the transition level.
BARO SET - Push and set (as required) PFDs - Crosscheck PM calls Transition, <Appropriate altimeter setting> PF calls <Appropriate altimeter setting>
Descending Descending through 18,000 feet MSL (PM) 18,000 (omit callout and accomplish Transition Level Flow first, if Through Transition Level is FL 180) SEAT BELTS - ON, ECAM - Checked, MCDU - Set 18.000 Feet
After the PF calls Descent - Approach Checklist Accomplish Descent - Approach Checklist
(PF) After the PM calls 18,000 (callout is replaced with the Transition callout, if Transition Level is FL 180) Call for Descent - Approach Checklist
Descending Just prior to descending through 10,000 feet MSL. (PM) 10,000 Through In-Range Report - Sent 10,000 Feet Landing After Landing
After extending the flaps to 3. (PM ENG MODE - NORM or IGN, After the PF calls Landing Checklist, Accomplish Landing Checklist) After the aircraft has cleared the active runway
After the captain calls Flaps - Up (or as operationally required) TCAS - STBY Flaps - UP (or as operationally required) ENG MODE - NORM SPEED BRAKE - RET & Disarmed Radar - OFF WINDSHEAR/PWS (as installed) - OFF APU (if required) - START
(PF) After the PM calls 10,000
External Lights - As required (As installed) NO PORTABLE ELEC DEVICE /NO SMOKING-ON or SEAT BELTS-Cycle (PF) Spoilers - Armed Call for Landing Checklist
Shutdown
After the aircraft is parked at the gate with parking brake set.
SEAT BELTS SIGNS- OFF NO PORTABLE ELEC DEVICE (if installed) - OFF ADIRS - Checked FDs - Recycle (Off, then On) After both engines are shut down Post Flight Report - Sent Jumpseat(s) (if previously occupied) - Stowed and Secured Respond during Shutdown Checklist ___ Disarmed
