Scribd
Upload
512 views1 page

2.1 Checking Installation Site Prerequisites: 2.2.1 CCM-Tool

The document discusses prerequisites and required service programs for installing a CR 85-X digitizer, including checking site prerequisites against a checklist, using the CCM-Tool configuration program to create a configuration file, and using an error message program to translate error codes to clear text.

Uploaded by

Arbjan Rusi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
512 views1 page

2.1 Checking Installation Site Prerequisites: 2.2.1 CCM-Tool

The document discusses prerequisites and required service programs for installing a CR 85-X digitizer, including checking site prerequisites against a checklist, using the CCM-Tool configuration program to create a configuration file, and using an error message program to translate error codes to clear text.

Uploaded by

Arbjan Rusi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DD+DIS378.

05E

Controls, Connections, and Setup Procedures

2.1

Checking Installation Site Prerequisites


Check that all site prerequisites shown in the Installation Planning-Checklist (can be found at the end of Chapter 11, CR 85-X Service Manual) are fulfilled before visiting the site.

2.2
2.2.1

Required Service Programs


CCM-Tool The CCM-Tool is needed to create and modify the configuration file (adc.cpf) for the CR 85-X and the other CR system components. The latest version of the CCM-Tool is installed by default on the NX processing station (Go to Start Agfa Service CCM Tools). If not yet done create and/or adapt the configuration file adc.cpf together with the application specialist. NOTE: When integrating the digitizer into an existing network, it is strongly recommended to create a CPF file beforehand (see CR 85-X Service Manual, Chapter 11, Installation Planning, checklist). For detailed information on the configuration file, see: ADC Application Manual - Chapter 11, DD+DIS181.03E.

2.2.2

Error Message Program The "SHOW ERROR PROGRAM" with the "ERROR.MSG file" translates the CR 85-X error codes into clear text. The "SHOW ERROR PROGRAM" is a part of IMOS, the "ERROR.MSG file" is loaded in the digitizer.

DOCUMENT CONTROL NOTE: The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.

Edition 2, Revision 1 06-2008

CR 85-X Type 5148/100 Chapter 1 / 7 CR 75.0 Type 5146/105 (as of SN 6000) Agfa Company Confidential

You might also like