HSE information sheet
Inspection and reports
Construction Information Sheet No 47(rev1)
Introduction
Reports
This information sheet sets out the specific
requirements for:
The result of an inspection must be recorded and
retained.
the inspection of:
If an inspection is of:
excavations of any depth;
an excavation, cofferdam or caisson; or
cofferdams and caissons;
existing places of work (which prevent falls
without the addition or use of other
equipment eg permanent guard rails on a
flat roof);
a working platform which is 2 metres or above in
height and is undertaken after installation or
assembly or to comply with the seven day
inspection regime;
work platforms (eg scaffolds, mobile
platforms);
collective fall arrest systems (eg nets,
airbags, soft landing systems);
personal fall protection systems (eg work
positioning, rope access, work restraint and
fall arrest systems);
the competent person must:
complete the inspection report before the end of
the working period; and
provide a copy of the report to the person for
whom the inspection was carried out within 24
hours.
The person receiving the report must:
keep it at the site where the inspection was
carried out until construction work is completed;
and
keep it at an office for a further three months.
ladders and stepladders;
the reports which have to be made following
inspections.
Page 2 contains a suggested report form. You do not
have to use this form. However, your record must
include the following information:
Inspections
The information in Table 1 outlines what must be
checked, inspected or examined under the
Construction (Health, Safety and Welfare)
Regulations 1996, the Lifting Operations and Lifting
Equipment Regulations 1998 and the Work at Height
Regulations 2005. It includes the timing and
frequency of those inspections.
Inspections should only be carried out by a
competent person. This is someone with the
experience, knowledge and appropriate qualifications
necessary to enable them to identify any risks that
are present and decide upon the measures required
to control those risks.
Stop work if the inspection shows it is not safe
to continue.
Name and address of the person for whom the
inspection was carried out.
Location of the place of work or work equipment
inspected.
Description of the place of work or work
equipment inspected.
Date and time of the inspection.
Details of any matter identified that could give rise
to a risk to the health or safety of any person.
Details of any action taken as a result of any
matter identified.
Details of any further action considered necessary.
Name and position of the person making the
report.
INSPECTION REPORT
1.
Name and address of person for whom inspection was carried out.
2.
Site address.
4.
Location and description of place of work or work equipment inspected.
5.
Matters which give rise to any health and safety risks.
6.
Can work be carried out safely?
7.
If not, name of person informed.
8.
Details of any other action taken as a result of matters identified in 5 above.
9.
Details of any further action considered necessary.
10.
Name and position of person making
the report.
11.
Date and time report handed over.
12.
Name and position of person receiving
report.
3.
Date and time of inspection.
Y/N
Table 1 Timing and frequency of checks, inspections and examinations
Timing and frequency of checks, inspections and examinations
Inspect
before work
at the start
of every
shift (see
note 1)
Inspect after
any event
likely to have
affected its
strength or
stability
Inspect after
accidental
fall of rock,
earth or
other
material
Excavations which are supported to prevent any
person being buried or trapped by an accidental
collapse or a fall or dislodgement of material
Cofferdams and caissons
Place of work or work equipment
The surface and every parapet or permanent rail of
every existing place of work at height
Guard rails, toe boards, barriers and similar collective
means of fall protection
Inspect after
installation or
assembly in
any position
(see notes 2
and 3)
Inspect
at
suitable
intervals
Inspect after
exceptional
circumstances which
are liable to
jeopardise the safety
of work equipment
Check on
each occasion
before use
(REPORT
NOT
REQUIRED)
LOLER Thorough
Examination (if
work equipment
subject to
LOLER) (see
note 4)
Scaffolds and other working platforms (including
tower scaffolds and MEWPs) used for construction
work and from which a person could fall more
than 2m
All other working platforms
Collective safeguards for arresting falls (eg nets,
airbags, soft landing systems)
Personal fall protection systems (including work
positioning, rope access, work restraint and fall arrest
systems)
Ladders and stepladders
Inspect at
intervals
not
exceeding
7 days (see
note 3)
Notes
1
Although an excavation must be inspected at the start of every shift, only one report is needed in any seven-day period. However, if something happens to affect its strength or
stability, and/or an additional inspection is carried out, a report must then be completed. A record of this inspection must be processed as outlined on page 1.
2
Installation means putting into position and assembly means putting together. You are not required to inspect and provide a report every time a ladder, tower scaffold or
mobile elevated work platform (MEWP) is moved on site or a personal fall protection system is clipped to a new location.
3
An inspection and a report is required for a tower scaffold or MEWP (used for construction work and from which a person could fall 2 metres) after installation or assembly and
every seven days thereafter, providing the equipment is being used on the same site. A record of this inspection must be processed as outlined on page 1. If a tower scaffold is
reassembled rather than simply moved, then an additional, pre-use inspection and report is required. It is acceptable for this inspection to be carried out by the person responsible
for erecting the tower scaffold, providing they are trained and competent. A visible tag system, which supplements inspection records as it is updated following each pre-use
inspection, is a way of recording and keeping the results until the next inspection.
4
All work equipment subject to LOLER regulation 9, thorough examination and inspection requirements, will continue to be subject to LOLER regulation 9 requirements.
Further information
HSE priced and free publications are available by mail
order from HSE Books, PO Box 1999, Sudbury, Suffolk
CO10 2WA Tel: 01787 881165 Fax: 01787 313995
Website: www.hsebooks.co.uk (HSE priced publications
are also available from bookshops and free leaflets can
be downloaded from HSEs website: www.hse.gov.uk.)
For information about health and safety ring HSEs
Infoline Tel: 0845 345 0055 Fax: 0845 408 9566
Textphone: 0845 408 9577 e-mail:
hse.infoline@natbrit.com or write to HSE Information
Services, Caerphilly Business Park, Caerphilly
CF83 3GG.
This leaflet contains mandatory requirements under the
Construction (Health, Safety and Welfare) Regulations
1996 and the Work at Height Regulations 2005.
Crown copyright This publication may be freely
reproduced, except for advertising, endorsement or
commercial purposes. First published 11/05. Please
acknowledge the source as HSE.
Printed and published by the Health and Safety Executive
CIS47(rev1)
11/05
C300
