Scribd
Upload
1K views1 page

0 Target Stand

This document provides instructions for building an archery target stand for around $25 using treated 1x4 lumber and stainless steel hardware. The stand gets targets very close to FITA specifications for height and angle. It can be built in a few hours and should last a long time, though 2x4 lumber can also be used if stability is more important than portability. The document includes a diagram and measurements for cutting the lumber pieces.

Uploaded by

Charles Calixto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

0 Target Stand

This document provides instructions for building an archery target stand for around $25 using treated 1x4 lumber and stainless steel hardware. The stand gets targets very close to FITA specifications for height and angle. It can be built in a few hours and should last a long time, though 2x4 lumber can also be used if stability is more important than portability. The document includes a diagram and measurements for cutting the lumber pieces.

Uploaded by

Charles Calixto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Target Stand Plans

This stand will get you VERY close to FITA specifications for height and angle when using a
48 or 52 target butt. They can be built in just a few hours, for around $25, using
treated 1 X 4s and stainless steel hardware. They should last a very long time. 2 X 4s can
also be used where the need for stability outweighs the need for portability. The bolts are
3/8 X 2-12. For 2 X 4s use 3/8 X 3 bolts. Use a 3/8 drill bit for a snug fit.
Designed by John W. Scott - Beaumont, TX
Cut crossmembers
(in blue) to 36
and secure with
deck screws.
Cut @ 45 angle measuring
1 from corner AFTER
measurements are made
and holes drilled.

9 1/2 in

72 in
72 in
Secure with
bolts, washers
and lock nuts.

51 in

13 3/4 in

2
Secure with
bolts, washers
and wing nuts.

48 in
30 1/2 in
24 3/4 in

Cut @ 30 angle AFTER


measurements are made
and holes drilled.

Cut crossmembers
(in blue) to 36
and secure with
deck screws.

Cut @ 15 angle AFTER


measurements are made
and holes drilled.

You might also like