Scribd
Upload
53 views2 pages

Top Cap Coil Base Heating Wire With Pure Cotton Insulating Ring Connect Pin

The ECR head consists of a top cap, heating wire, cotton wick, coil base, insulating ring and connect pin. To rebuild the coil yourself, you first remove parts and wrap the heating wire around a screwdriver. Then insert the ends of the heating wire and replace parts. Finally, remove the screwdriver, position the heating wire, stuff it with cotton, and cut excess cotton. Be sure to soak the cotton with e-liquid before vaping.

Uploaded by

ssm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
53 views2 pages

Top Cap Coil Base Heating Wire With Pure Cotton Insulating Ring Connect Pin

The ECR head consists of a top cap, heating wire, cotton wick, coil base, insulating ring and connect pin. To rebuild the coil yourself, you first remove parts and wrap the heating wire around a screwdriver. Then insert the ends of the heating wire and replace parts. Finally, remove the screwdriver, position the heating wire, stuff it with cotton, and cut excess cotton. Be sure to soak the cotton with e-liquid before vaping.

Uploaded by

ssm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ECR Head DIY

The ECR head is remarkably simple in structure, which consists of a top cap,
heating wire with pure cotton wick, coil base, insulating ring and connect pin.

top cap

heating wire
with pure cotton

coil base

insulating ring

connect pin

How to rebuild a coil by yourself?


First, pull out the top cap, the connect pin and insulating ring, roll the heating
wire around a screw driver and then fix the screw driver into the slot;

Second, put back the top cap,put one end of the heating wire between the notch

and the insulating ring and bend it down along the notch, put another end
through the insulating ring and bend it down, cut out the spare parts;

Third, put back the connect pin into the coil base, take out the screw driver and
place the heating wire in the middle position, cross pure cotton into the heating
wire, make sure the holes are well stuffed with pure cotton and finally cut out
spare parts along the holes.

Tips: Please first drip a few drops of e-liquid directly into the pure cotton so as to
make the cotton fully soaked before vaping.

You might also like