Balancing $ Eagle
By Jeremy Shafer ©1999
Tired of trying to balance your check book?
Try this model instead. It’s much easier to
balance and more fun too!
1 2
Make valley pinches at the sides.
Begin face up. Valley-fold and unfold in
half.
3 4
Make valley pinches at the sides.
Valley-fold the top and bottom edges to the
crease marks you just made.
5 6
Valley-fold and unfold. Unfold the top edge.
7
8
Valley-fold to where the creases meet. Valley-fold.
9
10
11
Valley-fold.
Valley-fold.
Valley-fold.
12
13
14
Outside-reverse-fold.
Outside-reverse-fold.
Valley-fold.
15 16 17
Valley-fold the the wings together, while
making a fish base out of the body.
Valley-fold and unfold. Sink.
18
19 20
Spread out the
tail feathers.
Valley-fold the wings up.
Valley-fold the wings to the side so that
the angle between them is 90°. Make
the wings go even further out with petal
folds.
21
22
Make two valley-folds on the
tail. Rabbit-ear the tip of the
head so that it sticks out.
Mountain-fold the tailfeathers.
23 24
Pull out the trapped paper. Turn the model over.
25 26
Reverse-fold the wings.
Make the end of the wing lock nicely by
inserting the lower layer into the upper layer.
27 28
Narrow the rear with mountains.
Bend the beak even more down.
Valley-fold and unfold. On the wings make a skyline of
mountains and valleys (i.e. make
lots of them).
29 30
The eagle has soared into existence. If done
correctly the pyramid on the dollar bill should
end up on the right wing and the eagle should Now try to balance the eagle on the pyramid.
end up on the left wing. Repositioning the beak is often necessary to
find the center of balance.
