Scribd
Upload
185 views4 pages

Calibration Process Steps

The document outlines 15 steps to calibrate test or measurement equipment in an SAP system. The steps include creating quality instruments and catalog codes in SAP, defining master inspection characteristics, creating sampling procedures and task lists, scheduling maintenance plans, recording inspection results, making usage decisions, and completing confirmation for the calibration process.

Uploaded by

Naveen Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
185 views4 pages

Calibration Process Steps

The document outlines 15 steps to calibrate test or measurement equipment in an SAP system. The steps include creating quality instruments and catalog codes in SAP, defining master inspection characteristics, creating sampling procedures and task lists, scheduling maintenance plans, recording inspection results, making usage decisions, and completing confirmation for the calibration process.

Uploaded by

Naveen Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Calibration Process Steps

Follow RSS feed


1 Like 10,866 Views 6 Comments

Introduction:

This scenario describes how to process the test or measurement equipment in a calibration inspection. The
objective of a calibration inspection is to determine whether each piece of equipment specified in the
maintenance order meets the predefined performance specifications.

Process Steps:

Step 1: Create Quality Instrument as Equipment in SAP System

Step 2: Create Catalog Code groups & corresponding codes

Step 3: Create Selected Sets

Step 4: Create Master Inspection Characteristics (MIC)

All the Qualitative & Quantitative parameters will be created as Master Inspection Characteristics in SAP
system.
Step 5: Create Sampling Procedure to create the samples out of multiple equipments.

If Inspection will be done on 100 % sample, make the sampling type as 100 % Inspection.

Step 6: Create Task List for Quality Inspection.

There are different types of Task lists available. Here based on the requirement, either Equipment Task List or
General Task list will be created.

Step 7: Create Maintenance Strategy to define the Calibration Frequency (Required only in case of Strategy
Plan is used for Calibration)

Step 8: Create Maintenance Plan for Calibration Process


Step 9: Schedule the Maintenance Plan

Step 10: Display the Orders created based on Scheduling

Step 11: Release the order

Step 12: Results Recording for the Inspection Lot

Step 13: Usage Decision for the Inspection Lot

Step 14: Do the Completion Confirmation for PM Order operations


Step 15: Do the TECO for PM Order

You might also like