F BRAKES

B
SECTION
PARKING BRAKE SYSTEM C

E
CONTENTS
PARKING BRAKE CONTROL ................................... 2 SERVICE DATA AND SPECIFICATIONS (SDS) ........ 4 PB
Components ............................................................. 2 Drum Brake .............................................................. 4
Removal and Installation .......................................... 2 Parking Brake Control .............................................. 4
Inspection ................................................................. 2 G
Adjustment ............................................................... 3

PB-1
 PARKING BRAKE CONTROL

PARKING BRAKE CONTROL PFP:36010

Components EFS003G9

LBR393

Removal and Installation EFS003GA

1. To remove parking brake pedal, remove lower instrument panel

on driver side. Refer to IP-10, "INSTRUMENT PANEL ASSEM-
BLY" .
2. Disconnect parking brake switch electrical connector.
3. Remove nuts, slacken off and remove adjusting nut.
4. Remove pedal assembly from vehicle and remove front cable
from pedal assembly.

LBR394

Inspection EFS003GB

1. Check parking brake pedal assembly for wear or other damage. Replace if necessary.
2. Check cables for discontinuity or deterioration. Replace if necessary.
3. Check warning lamp and switch. Replace if necessary.
4. Check parts at each connection portion and, if found deformed or damaged, replace.

PB-2
 PARKING BRAKE CONTROL

Adjustment EFS003GC

A
Pay attention to the following point after adjustment.
1. Ensure there is no drag when pedal is released.
2. Loosen parking brake cable. B
3. Depress parking brake pedal fully more than five times.
4. Operate control pedal 10 times or more with a full stroke [169
mm (6.6 in)]. C
5. Adjust cable by turning adjusting nut.
6. Depress pedal with specified amount of force. Check pedal
stroke and ensure smooth operation. D
WBR348
Force : 196 N (20 kg, 44 lb)
Number of notches
E
KA24DE models :6–8
VG33E and VG33ER :7–9
models PB
7. Bend warning lamp switch plate. Warning lamp should come on when pedal is depressed “A” notches. It
should go off when the pedal is fully released.
G
Number of “A” notches for :1
warning lamp actuation

PB-3
 SERVICE DATA AND SPECIFICATIONS (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS) PFP:00030

Drum Brake EFS003GD

Unit: mm (in)
Brake model LT26 LT30
Lining wear limit Minimum thickness 1.5 (0.059)
Maximum inner diameter 261.5 (10.30) 296.5 (11.67)
Drum repair limit
Out-of-round limit 0.03 (0.0012)

Parking Brake Control EFS003GE

Unit: notch
Control Type Pedal

Pedal stroke KA24DE 6-8

[under force of 196 N (20 kg, 44 lb)] VG33E and VG33ER 7-9
Pedal stroke when warning switch comes on 1
Full pedal stroke 169 mm (6.6 in)

PB-4