ENHANCED POWER GATING SCHEMES FOR LOW LEAKAGE LOW GROUND BOUNCE NOISE IN DEEP SUBMICRON CIRCUITS
ABSTRACT:
The development of digital integrated circuits is challenged by higher power consumption. The combination of higher clock speeds, greater functional integration, and smaller process geometries has contributed to significant growth in power density. Scaling improves transistor density and functionality on a chip. Scaling helps to increase speed and frequency of operation and hence higher performance. But the leakage due to ground connection to the active part of the circuit is very high rather than all other leakages. In this paper we are going to design such an efficient technique related to ground bounce noise reduction using power gating circuits
EXISTING SYSTEMS:
Existing system is using Power gating circuits which will most probably reduce the complexity of the circuit. As complexity reduced power consumption can be further more reduced. The Existing system is very much immune to the ground bounce noise.But it need more components (Inductor,Transmission gates) Increase circuit complexity
EXISTING CIRCUIT:
PROPOSED SYSTEM:
In Proposed system we provide novel circuit structure named Dual stack as a new remedy for designers in terms of static power and dynamic powers. Novel technique there are two sleep transistors is forcedly stacked in both pull-up and pull-down networks It maintaining the exact logic state, two extra transistors are used with the pull-up and pull-down networks.
PROPOSED POWER GATING CIRCUIT:
Novel stacked sleep approach
CONCEPT OF GROUND BOUNCE
Quiet Device Output That Is Affected
System Input That is Affected
Load Capacitance
Inductance of lead frame, bound wired, package pin, etc.
Current flow (red) during a high to low transition causing bounce. This can change the input thresholds to the device as well as result in output pulses being transmitted to a receiver.
GROUND BOUNCE - DEFINITION
Noise on a quiet output. Voltage with respect to ground.
Switching Outputs
High Quiet Output
VOHP VOHV VOLP VOLV
Low Quiet Output
VDD BOUNCE
GROUND BOUNCE - DEFINITION XILINX TERMINOLOGY
GROUND BOUNCE - MEASURING
Measured on pin with greatest noise. Worst-case pin usually furthest from ground. VOLP and VOLV are measured on a quiet line that is a 0; switching outputs transition from high to low for ground bounce. VOHP and VOHV are measured on a quiet line that is a 1; switching outputs transition from low to high for supply droop.
GROUND BOUNCE - MEASURING
GROUND BOUNCE - MEASURING WORST-CASE VS. BEST-CASE PIN
Worst-case
Best-case
GROUND BOUNCE - MEASURING
Design system and test equipment to support measurement of ground bounce
Control of patterns
When using reprogrammable devices
Special patterns can be loaded to exercise the I/O buffers and measure ground bounce.
REDUCING GROUND BOUNCE
Use low slew outputs unless needed Dont group SSOs together; break them up.
Xilinx: two for each side of a ground pin Example: Do address and data busses need to switch at the same time?
Control number of SSOs through sequencing
For some families [fill in], programming unused outputs will improve grounding or supply for output stages.
REDUCING GROUND BOUNCE
Use buffers, particularly for large memory arrays or long lines
Everything does not have to be inside of the FPGA or ASIC
Avoid sockets For spare pad locations, pre-wire power, ground, and bypass capacitor connections
haywired power and ground connections will have unneeded inductance.
TOOLS USED
DSCH Microwind
APPLICATIONS:
In future mobile Systems for low leakage & enhanced battery efficiency. Future Integrated circuits for low power and high speed applications using power gated cicuits.
APPLICATIONS
In future mobile Systems for low leakage & enhanced battery efficiency. Future Integrated circuits for low power and high speed applications using power gated cicuits.
REFERENCES
Kim Suhwan, S.V. Kosonocky, D. R Knebel, K. Stawiasz, M. e. Papaeftbymiou, "IEEE Journal of Circuit and systems II: Express briefs, pp. 586-590, 2007. Suhwan Kim, Chang Jun Choi, Deog- Kyoon Jeong, Kosonocky, Sung Bac Park, " Reducing ground bounce noise and stabilizing he data- retention voltage of power- gating structures" IEEE transactions on Electron Devices, vol. 55, pp. 197-205, June 2008. Shilpi Birla, Neeraj K. Shukla, Manisha Pattanaik and R. K Singh "Analysis of the data stability and leakage reduction in the various SRAM cells topologies", International Journal of engineering science & technology computer (HEST), Singapore, vol. 2(7), 2010, pp. 2936-2944, ISSN: 0975- 5462. M. Tie, H. Dong, T. Wong, Xu Cheng, " Dual- Vth leakage reduction with fast clock skew scheduling enhancement", IEEE conference on Design Automation & Test in Europe, 2010, pp. 520-525.
