PCN

This document specifies extensions to Generic Aggregate RSVP (RFC 4860) for support of the Pre-Congestion Notification (PCN) Controlled Load (CL) and Single Marking (SM) edge behaviors over a Diffserv cloud using PCN.

The objective of Pre-Congestion Notification (PCN) is to protect the quality of service (QoS) of inelastic flows within a Diffserv domain. On every link in the PCN-domain, the overall rate of PCN-traffic is metered, and PCN-packets are appropriately marked when certain configured rates are exceeded. Egress nodes provide decision points with information about the PCN-marks of PCN-packets that allows them to take decisions about whether to admit or block a new flow request, and to terminate some already admitted flows during serious \%pre-congestion.

The PCN working group explored a number of approaches for encoding this pre-congestion information into the IP header. This document provides details of those approaches along with an explanation of the constraints that apply to any solution. This document is not an Internet Standards Track specification; it is published for informational purposes.

The objective of Pre-Congestion Notification (PCN) is to protect the quality of service (QoS) of inelastic flows within a Diffserv domain. The overall rate of PCN-traffic is metered on every link in the PCN- domain, and PCN-packets are appropriately marked when certain configured rates are exceeded. Egress nodes pass information about these PCN-marks to Decision Points that then decide whether to admit or block new flow requests or to terminate some already admitted flows during serious pre-congestion.

This document specifies how PCN-marks are to be encoded into the IP header by reusing the Explicit Congestion Notification (ECN) codepoints within a PCN-domain. The PCN wire protocol for non-IP protocol headers will need to be defined elsewhere. Nonetheless, this document clarifies the PCN encoding for MPLS in an informational appendix. The encoding for IP provides for up to three different PCN marking states using a single Diffserv codepoint (DSCP): not-marked (NM), threshold-marked (ThM), and excess-traffic-marked (ETM). Hence, it is called the 3-in-1 PCN encoding. This document obsoletes RFC 5696. [STANDARDS-TRACK]

Pre-Congestion Notification (PCN) is a means for protecting the quality of service for inelastic traffic admitted to a Diffserv domain. The overall PCN architecture is described in RFC 5559. This memo is one of a series describing possible boundary-node behaviors for a PCN-domain. The behavior described here is that for a form of measurement-based load control using three PCN marking states: not- marked, threshold-marked, and excess-traffic-marked. This behavior is known informally as the Controlled Load (CL) PCN-boundary-node behavior. This document defines an Experimental Protocol for the Internet community.

Pre-Congestion Notification (PCN) is a means for protecting the quality of service for inelastic traffic admitted to a Diffserv domain. The overall PCN architecture is described in RFC 5559. This memo is one of a series describing possible boundary-node behaviors for a PCN-domain. The behavior described here is that for a form of measurement-based load control using two PCN marking states: not- marked and excess-traffic-marked. This behavior is known informally as the Single Marking (SM) PCN-boundary-node behavior. This document defines an Experimental Protocol for the Internet community.

Pre-Congestion Notification (PCN) is a means for protecting quality of service for inelastic traffic admitted to a Diffserv domain. The overall PCN architecture is described in RFC 5559. This memo describes the requirements for the signaling applied within the PCN-domain: (1) PCN-feedback-information is carried from the PCN-egress-node to the Decision Point; (2) the Decision Point may ask the PCN-ingress-node to measure, and report back, the rate of sent PCN-traffic between that PCN-ingress-node and PCN-egress-node. The Decision Point may be either collocated with the PCN-ingress-node or a centralized node (in the first case, (2) is not required). The signaling requirements pertain in particular to two edge behaviors, Controlled Load (CL) and Single Marking (SM). This document is not an Internet Standards Track specification; it is published for informational purposes.

The objective of Pre-Congestion Notification (PCN) is to protect the quality of service (QoS) of inelastic flows within a Diffserv domain in a simple, scalable, and robust fashion. This document defines the two metering and marking behaviours of PCN-nodes. Threshold-metering and -marking marks all PCN-packets if the rate of PCN-traffic is greater than a configured rate ("PCN-threshold-rate"). Excess- traffic-metering and -marking marks a proportion of PCN-packets, such that the amount marked equals the rate of PCN-traffic in excess of a configured rate ("PCN-excess-rate"). The level of marking allows PCN-boundary-nodes to make decisions about whether to admit or terminate PCN-flows. [STANDARDS-TRACK]

This document describes a general architecture for flow admission and termination based on pre-congestion information in order to protect the quality of service of established, inelastic flows within a single Diffserv domain. This memo provides information for the Internet community.