Increasing the functionality of the segmented LCD on the MSP-EXP430FR4133.

This library interfaces with the Texas Instruments BQ27441 Battery Fuel Gauge using software I2C. This allows the device to be connected to any two available I/O pins instead of the hardware-specific I2C peripheral pins.

This sketch implements a simple external hardware watchdog that can be loaded onto a low-end MSP processor to provide a watchdog reset signal. It should also work on AVR processors, although it has not been tested on AVRs

A slightly faster (lower level) AS5600 I2C library for atmega328p, ESP32, MSP430 or STM32 (or Wire.h)

C++ objects that are drivers for various MSP430 peripherals and other chips controlled by a MSP430 using GPIO

A portable, low-cost oscilloscope for laboratory and educational usage.

Library and example for TI MSP430 LaunchPads and Energia that reads a card number from RFID_RC522 without RST pin

Electric bicycle main controller based on TI Launchpad. Software part.

Wireless temperature sensor which uses an MSP-EXP430FR2433 LaunchPad, 430BOOST-CC110L wireless transceiver, BOOSTXL-BATTPACK LiPo power source, and 430BOOST-SHARP96 low-power display.

A library for the CAP1293 touch sensor for atmega328p, ESP32, MSP430 or STM32 (or Wire.h)

Library for an I2C command interface to the HapTouch BoosterPack.

MSP430-based low-power wireless temperature sensor using waterproof DS18B20 module. Demonstrates use of OneWire protocol and low-power wireless operation.

LLVM/clang toolchain for TI MSP430

Environment sensor with temperature, relative humidity and CO2, based on MSP-EXP430FR4133

Grant Forest (from https://www.43oh.com) DS18B20 library for TI TMS320 and MSP340 with Energia IDE

PID climate control for water heating

🗂️ Projetos com Microcontroladores

Utilizing I2C protocol on MSP430 MCU to communicate with a temperature sensor