My Stampin up cards

These are hand crafted cards using some stampin up products Here are the Instructions for the Tasty truck card Main base card i used denim dapper is 6"x 91/4" scored at 4x 5/8" Peekaboo Peach is 4 3/8 " x 5 5/8" Whisper white is 4 1/4" x 5 1/2" 2 - 4" die cut circles one on white card the other on copy paper Duet banner,punch, brad Dimensionals . Strong Adhesive Markers of your choice to colour. I have put photos up they are numbered 1-25 sorry there are so many but it shows step by step. Fold in half the copy paper then turn again to fold into quarters this is used as a guide to make a hole in the centre then get your 2nd card circle and place under the copy paper, poke hole thorough both you don't need to fold the card. This is for the brad. Cut out the window in the tasty truck. Then put the card circle behind the card this is to see if it's not to high or to low but make sure it covers the window, when your happy with positioning get your pokey tool and pierce the card front. There will be a few times we put the brad in it's only to see that things are lined up correctly. Put the brad in split the ends and see how it turns then on each rough quarter draw a light pencil line inside the window as in the photo. Spin round about a quarter and do the same till all four are drawn I lifted the card while doing it to make sure there were roughly all the same space apart, then take the brad out. Then stamp your images/ sentiments it's best to stamp near the bottom of the line in each rectangle box just make sure the stamp fits in the box then colour in and set aside to dry before you erase the pencil lines. Then colour your truck images. once dry erase the lines put the brad in again split the ends it should be spin and every box will have a picture with the brad in mark your card on the right where it's going to be punched take the brad out, and punch half a circle in the card. I don't have a circle punch I use a corner of my heart punch it worked fine. Line up the white card with the peekaboo Peach card and where the white is punched draw a half circle on the Peach card and punch again same with the base card align up only punch the top of the base card not the back. Now to assemble the card insert the brad again and split the ends the put strong adhesive round the card don't put glue or adhesive anywhere near the wheel as it won't turn. Same again with the peekaboo Peach card and stick on your base card . You can leave the brad as it is or cover it up with a banner from the duet banner punch then add on dimensionals To the banner I drew 2 lines with a fine liner pen so it looks like poles holding it up. Thanks ladies any problems message me happy crafting xx