MNT.8:4 - Solution
Recover the proposed work scope, actual configuration, relevant hazards and applicable procedure. Qualified people determine the equipment- and jurisdiction-specific controls. If the procedure’s applicability or the authority to act is unresolved, return that limit before the affected work begins.
Trace the exposure paths needed for the intervention. Depending on the equipment, these can include electrical, mechanical, hydraulic, pneumatic, thermal, chemical or other sources, including stored or reaccumulating energy. Use the applicable procedure and hazard analysis to identify the sources for this job. A control-system stop command is not assumed to be an energy-isolating measure.
Establish the selected isolation and protective conditions through the applicable procedure. Verify the condition that protects the people who will perform the work, using the required competent personnel and suitable means. A signed statement is evidence only to the extent that it supports the actual condition and applicable authority.
Coordinate people whose work can alter that condition. Where contractors, groups, shift changes or simultaneous jobs are involved, maintain the required protection and control through those transitions. A person leaving the work area does not by itself resolve the transfer of protection or permission.
Define the bounded permission for the actual intervention: permitted scope, configuration, protection conditions and the material change that requires a hold or revised decision. During work, respond to a loss of protection or an unexpected condition using the applicable safe hold, restoration or reassessment procedure. Testing that needs an energized or otherwise changed state has its own controlled transition; initial isolation does not authorize any later test state.
If a requirement’s merits are disputed, use a separate appraisal. Identify the protected bearer, relevant harm and causal basis, baseline and incremental protection, whole burden and displaced harms. Compare harmful relaxation with harmful retention or tightening, and name who may amend the requirement. Until an authorized change applies, preserve current force. This separation permits substantive criticism without turning a framework discussion into permission to bypass a control.
Return permission only for the supported work and conditions, or state the missing protection, applicability or authority. Keep evidence proportionate to the actual reliance and applicable requirements.
A request to assess a proposed protection arrangement can be completed before the intervention. Follow any shared exposure or change of state that would matter to the permitted work and identify the conditions the proposal would require. To report that permission was granted for a particular act, use the governing decision and its scope. To start the work, establish the required protection in the actual configuration under the applicable procedure.