This folder contains supplementary scripts that automates routine actions. Flashing scripts are based on cli version of STM32CubeProgrammer. You will need to add STM32_Programmer_CLI to your path to use them.
Always flash your device in the following sequence:
- OTP (Only on empty MCU)
- Core1 and Core2 firmware flashing
- Option Bytes
!!! Flashing incorrect OTP may permanently brick your device !!!
Normally OTP data generated and flashed at the factory.
In case if MCU was replaced you'll need correct OTP data to be able to use companion applications.
Use otp.py to generate and flash OTP data.
You will need exact main board revision to generate OTP data. It can be found on main PCB.
Also display type, region and etc...
!!! Flashing incorrect OTP may permanently brick your device !!!
Core2 goes first, then Core1. Never flash FUS or you will lose your job, girlfriend and keys in secure enclave.
!!! Setting incorrect Option Bytes may brick your MCU !!!
Defaults are mostly OK, but there are couple things that we'd like to tune. Also, OB may be damaged, so we've made couple scripts to check and set option bytes.
!!! Setting incorrect Option Bytes may brick your MCU !!!
Checking option bytes:
ob.py checkSetting option bytes:
ob.py setRun in the root folder of the repo:
python scripts/storage.py -p <flipper_cli_port> send assets/resources /extPut fullscreen slideshow frames in .png format into assets/slideshow/my_show folder, named frame_xx.png, where xx is zero-padded frame number, starting with #0.
Then run
python scripts/slideshow.py -i assets/slideshow/my_show/ -o assets/slideshow/my_show/.slideshowUpload generated .slideshow file to Flipper's internal storage and restart it.