Modular Vise
Divided into two modules, the modular vice offers great flexibility when it comes to quickly and safely clamping medium to large components on a T-slot plate. The application is conceivably simple and fast: the jaws of the vise, which are freely movable in the grooves, are pushed against the component, the group aligned and tightened with screws and slot nuts. The fixation of the workpiece is then done by tightening the claws. The often cumbersome handling with clamping claws, tie rods and step blocks is thus obsolete.
On the underside of the middle part guide pins can be used to facilitate the longitudinal alignment in a T-slot, if necessary.
With a second vice side and other (e.g., knife) clamps, the kit can be expanded to a full system for a huge variety of clamping tasks.
Dimensions:
Jaw: W x D x H approx. 95 x 100 x 29 mm
Middle section: W x D x H approx. 48 x 100 x 25 mm
Scope of delivery:
1 x vise jaw
1 x middle part
1 x clamping bar
1 x soft jaw for middle section
2 x guide pin for middle section
4 x screws M6 x 30
2 x pitbull clamp blunt
Manufacturer: | Responsible person: |
| Safety instructions: | ||
| 1. | Always read and observe the safety instructions and warnings in the available documents. | |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |