Scribd
Upload
2K views3 pages

1.4 Wire Splicing

The Liverpool splice is a simple but widely used splice for joining wire ropes. It involves tucking the working strands of the rope in a specific pattern under strands of the standing part. To make the splice, the working strands are each tucked three times for a total of four tucks per strand. The strands are tucked one under the other to bind them together securely. Once complete, the splice is pounded into shape with a rubber hammer.

Uploaded by

commando
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views3 pages

1.4 Wire Splicing

The Liverpool splice is a simple but widely used splice for joining wire ropes. It involves tucking the working strands of the rope in a specific pattern under strands of the standing part. To make the splice, the working strands are each tucked three times for a total of four tucks per strand. The strands are tucked one under the other to bind them together securely. Once complete, the splice is pounded into shape with a rubber hammer.

Uploaded by

commando
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

1.

4 WIRE SPLICING

The Liverpool is one of the most popular splices, and is the most simple splice to make. It is used
widely, but do not use it in a rope that is free to spin when loaded.

The following describes the procedures to make the Liverpool eye splice:

1. Insert a spike against the lay, under three strands of the standing part. Tuck the working strand
one under three strands with the lay, as shown in figure (a) below;

2. Tuck working strand two through the same opening as working strand one, but under two strands,
as shown in figure (b) below;

3. Tuck working strand three through the same opening as the first two working strands, but under
only one strand, so all three working strands go in at the same point, but come out at different
places (c);

4. Turn the eye over, then put the spike under the strand of the standing part to the left of the last
three tucks. Turn the spike counter clockwise around the standing part, and tuck the working strand
four with the lay. Pull the strand down tight with the spike. Tuck strand four around the same strand
four times. Each tuck must be locked in place by holding the strand down and running the spike up
(d);
5. Similarly, put the spike under the next higher strand on the standing part and tuck the 5th strand
with the lay around it four times (e).

6. Strand six is also tucked with the lay around the next higher strand on the standing part (f);

7. Tuck strand one, two and three. Each is tucked three times in a row, ending up with four tucks for
each strand. There is a way to avoid kinking strands when pulling them into the place. Insert the
spike and run it up the wire of the standing part. As the spike runs up with the strand, shove the
working strand under the spike and pull it taut. Keeping the strain on the working strand, work the
spike down to push the working strand back around and down. Hold the working strand where it is,
and work the spike back up the wire. Follow up with the strand, and take the last tuck. Work that
strand back down and hold it there. Pull out the spike, and run it back up until the strands of the
standing wire bind the working strand in place. Make the second and third tucks with the remaining
strands in the same way.
8. Remove the wire from the vise, use a rubber hammer to pound the splice into shape, and cut off
the ends of the tucking strands close to complete the splice.

You might also like