Smartzworld.
com
UNITIII
Maxwell's equations (Time varying fields)
Faraday’s law, transformer emf &inconsistency of ampere’s law
Displacement current density
Maxwell’s equations in final form
Maxwell’s equations in word form
Boundary conditions: Dielectric to Dielectric& Dielectric to conductor
m
. co
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
Introduction:
In our study of static fields so far, we have observed that static electric fields are produced by
electric charges, static magnetic fields are produced by charges in motion or by steady current.
Further, static electric field is a conservative field and has no curl, the static magnetic field is
continuous and its divergence is zero. The fundamental relationships for static electric fields
among the field quantities can be summarized as:
(1)
(2)
For a linear and isotropic medium,
(3)
m
Similarly for the magnetostatic case
co
(4)
(5)
.
(6)
ld
or
It can be seen that for static case, the electric field vectors and and magnetic field
vectors and form separate pairs.
w
In this chapter we will consider the time varying scenario. In the time varying case we
tz
will observe that a changing magnetic field will produce a changing electric field and vice versa.
ar
We begin our discussion with Faraday's Law of electromagnetic induction and then
Sm
present the Maxwell's equations which form the foundation for the electromagnetic theory.
Faraday's Law of electromagnetic Induction
Michael Faraday, in 1831 discovered experimentally that a current was induced in a
conducting loop when the magnetic flux linking the loop changed. In terms of fields, we can say
that a time varying magnetic field produces an electromotive force (emf) which causes a current
in a closed circuit. The quantitative relation between the induced emf (the voltage that arises
from conductors moving in a magnetic field or from changing magnetic fields) and the rate of
change of flux linkage developed based on experimental observation is known as Faraday's law.
Mathematically, the induced emf can be written as Emf = Volts
(7)
Smartzworld.com
Smartzworld.com
where is the flux linkage over the closed path.
A non zero may result due to any of the following:
(a) time changing flux linkage a stationary closed path.
(b) relative motion between a steady flux a closed path.
(c) a combination of the above two cases.
The negative sign in equation (7) was introduced by Lenz in order to comply with the
polarity of the induced emf. The negative sign implies that the induced emf will cause a current
flow in the closed loop in such a direction so as to oppose the change in the linking magnetic
flux which produces it. (It may be noted that as far as the induced emf is concerned, the closed
m
path forming a loop does not necessarily have to be conductive).
If the closed path is in the form of N tightly wound turns of a coil, the change in the
co
magnetic flux linking the coil induces an emf in each turn of the coil and total emf is the sum of
the induced emfs of the individual turns, i.e.,
.
ld
or
Emf = Volts (8)
By defining the total flux linkage as
w
(9)
tz
The emf can be written as
ar
Emf = (10)
Sm
Continuing with equation (3), over a closed contour 'C' we can write
Emf = (11)
where is the induced electric field on the conductor to sustain the current.
Further, total flux enclosed by the contour 'C ' is given by
(12)
Where S is the surface for which 'C' is the contour.
From (11) and using (12) in (3) we can write
(13)
Smartzworld.com
Smartzworld.com
By applying stokes theorem
(14)
Therefore, we can write
(15)
which is the Faraday's law in the point form
We have said that non zero can be produced in a several ways. One particular case is when a
time varying flux linking a stationary closed path induces an emf. The emf induced in a
stationary closed path by a time varying magnetic field is called a transformer emf .
m
Motional EMF:
co
Let us consider a conductor moving in a steady magnetic field as shown in the fig 2.
.
ld
or
w
tz
Fig 2
ar
If a charge Q moves in a magnetic field , it experiences a force
Sm
(16)
This force will cause the electrons in the conductor to drift towards one end and leave the other
end positively charged, thus creating a field and charge separation continuous until electric and
magnetic forces balance and an equilibrium is reached very quickly, the net force on the moving
conductor is zero.
can be interpreted as an induced electric field which is called the motional electric
field
(17)
If the moving conductor is a part of the closed circuit C, the generated emf around the circuit is
Smartzworld.com
Smartzworld.com
. This emf is called the motional emf.
m
. co
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
Inconsistency of amperes law
m
co.
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
m
co.
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
m
co.
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
m
co.
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
Concept of displacementcurrent
m
co.
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
m
co.
ld
or
w
tz
ar
Sm
Smartzworld.com
Smartzworld.com
m
Maxwell's Equation
co
Equation (5.1) and (5.2) gives the relationship among the field quantities in the static field. For
time varying case, the relationship among the field vectors written as
.
ld
(1)
or
…………..(2)
w
(3)
tz
(4)
ar
In addition, from the principle of conservation of charges we get the equation of continuity
Sm
The equation must be consistent with equation of continuity
We observe that
(5)
Since is zero for any vector .
Thus applies only for the static case i.e., for the scenario when .
A classic example for this is given below .
Suppose we are in the process of charging up a capacitor as shown in fig 3.
Smartzworld.com
Fig 3
Let us apply the Ampere's Law for the Amperian loop shown in fig 3. Ienc = I is the total current
passing through the loop. But if we draw a baloon shaped surface as in fig 5.3, no current passes
through this surface and hence Ienc = 0. But for non steady currents such as this one, the concept
of current enclosed by a loop is illdefined since it depends on what surface you use. In fact
Ampere's Law should also hold true for time varying case as well, then comes the idea of
displacement current which will be introduced in the next few slides.
We can write for time varying case,
………….(1)
…………….(2)
………… (3)
The equation (3) is valid for static as well as for time varying case.Equation (3) indicates that a
time varying electric field will give rise to a magnetic field even in the absence of The term
has a dimension of current densities and is called the displacement current density.
Introduction of in equation is one of the major contributions of Jame's Clerk
Maxwell. The modified set of equations
(4)
Smartzworld.com
(5)
(6)
(7)
is known as the Maxwell's equation and this set of equations apply in the time varying scenario,
static fields are being a particular case .
In the integral form
(8)
………… (9)
(10)
(11)
The modification of Ampere's law by Maxwell has led to the development of a unified
electromagnetic field theory. By introducing the displacement current term, Maxwell could
predict the propagation of EM waves. Existence of EM waves was later demonstrated by Hertz
experimentally which led to the new era of radio communication.
Smartzworld.com
Smartzworld.com
Boundary Conditions for Electromagnetic fields
The differential forms of Maxwell's equations are used to solve for the field vectors provided the
field quantities are single valued, bounded and continuous. At the media boundaries, the field
vectors are discontinuous and their behaviors across the boundaries are governed by boundary
conditions. The integral equations(eqn 5.26) are assumed to hold for regions containing
discontinuous media.Boundary conditions can be derived by applying the Maxwell's equations in
the integral form to small regions at the interface of the two media. The procedure is similar to
those used for obtaining boundary conditions for static electric fields (chapter 2) and static
magnetic fields (chapter 4). The boundary conditions are summarized as follows
With reference to fig 5.3
Fig 5.4
We can says that tangential component of electric field is continuous across the interface while
from 5.27 (c) we note that tangential component of the magnetic field is discontinuous by an
amount equal to the surface current density. Similarly 5 states that normal component of electric
flux density vector is discontinuous across the interface by an amount equal to the surface
current density while normal component of the magnetic flux density is continuous.
If one side of the interface, as shown in fig 5.4, is a perfect electric conductor, say region 2, a
surface current can exist even though is zero as .
Smartzworld.com
Smartzworld.com
Thus eqn 5 reduces to
Questions:
Smartzworld.com
Smartzworld.com
Bits:
1. 1 A field can exist if it satisfies all Maxwell’s equations
2. Displacement current density is
3. If ,E=10.0V/m, the conduction current density is 20.0A/m2
4. The electric field in free space is
5. If E=2V/m of a wave in free space, (H) is
6. The electric intensity, E at a point (1,2,2) due to (1/9)nC located at (0,0,0)is 0.33V/m
7. If E is a vector, then is zero
8. The Maxwell equation is due to nonexistence of a mono pole
9. The electric field for time varying potentials
10. The intrinsic impedence of the medium whose is
11. The electric field just about a a conductor is always normal to the surface
12. The normal component of D are continuous ay dielectric boundary
13 The first Maxwell,s equation in free space is
14.Maxwell,s equations gives relation b/w different fields
15.The boundary condition on H is
16.If mho/m, E=10.0V/m, the conduction current density is 20.0A/m2
17.The boundary condition on E is
18.The wave length of a wave with propagation constant is 10m
19.The normal component of D are Continuous across a dielectric boundary
20.If Jc=1mA/m2 in a medium whose conductivity is ,E is 0.1V/m
Smartzworld.com
