Scribd
Upload
362 views12 pages

Front Bumper: Removal - Refitting

The front bumper removal and refitting process involves the following steps: 1. For removal, disconnect connectors, remove bolts and clips to detach the bumper. Lift it off with two people. 2. For refitting, reconnect any connectors, attach the bumper with bolts and clips with help from another person. 3. Finish by reattaching trim pieces, bolting everything securely, and testing functions. Check tire size markings to ensure correct bumper model.

Uploaded by

lukasz_b7
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
362 views12 pages

Front Bumper: Removal - Refitting

The front bumper removal and refitting process involves the following steps: 1. For removal, disconnect connectors, remove bolts and clips to detach the bumper. Lift it off with two people. 2. For refitting, reconnect any connectors, attach the bumper with bolts and clips with help from another person. 3. Finish by reattaching trim pieces, bolting everything securely, and testing functions. Check tire size markings to ensure correct bumper model.

Uploaded by

lukasz_b7
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 12

FRONT BUMPER: REMOVAL - REFITTING

REMOVAL

1. REMOVAL PREPARATION OPERATION

Position the vehicle on a two-post liftVehicle: Towing and lifting (MR 392, 02A, Lifting equipment).

Remove:

the lower bolts(1) .

the front parts of the front wheel arch liners(see 55A, Exterior protection, Front wheel arch liner:
Removal - Refitting) .

-1-
Disconnect the connector(2) (depending on equipment level).

2. OPERATION FOR REMOVAL OF PART CONCERNED

-2-
Remove the bolts(3) .

-3-
Remove the bolts and clips(4) .

-4-
Unclip the side sections of the front bumper.

Remove the front bumper unit (this operation requires two people).

Disconnect the headlight washer jet supply (depending on equipment level).

REFITTING

-5-
1. REFITTING PREPARATION OPERATION

Note:

During a replacement operation, order the front bumper according to the mark(6) on the front
wing of the vehicle:

tyre size smaller than or equal to 185= mark on front wing(6) which reads 185,

tyre size 195= mark on front wing(6) which reads 195.

Unclip the trim(5) .

-6-
Check the tyre size(6) .

2. REFITTING OPERATION FOR PART CONCERNED

Connect the headlight washer jet supply (depending on equipment level).

Refit the front bumper unit (this operation requires two people).

-7-
Refit the bolts(7) .

-8-
Refit the bolts and clips(8) .

-9-
Refit the bolts(9) .

3. FINAL OPERATION

- 10 -
Connect the connector(10) (depending on the equipment level).

Test all of the functions with a function test (depending on equipment level).

Refit the front parts of the front wheel arch liners(see 55A, Exterior protection, Front wheel arch liner: Removal -
Refitting) .

- 11 -
Repair-50x05x02-01x37-1-9-1.xml

XSL version : 3.02 du 22/07/11

- 12 -

You might also like